Hello group. I got the wl-005g model ,2.4 board revision router this week,so I
decided to flash it with v1.9.2.7 cr5a and everything appeared fine so I decided to flash with cr6a. I had disconnected leads and cables to enable a clean reboot prior to flashing, after it rebooted i noticed that the wireless connection was poor,dropping and intermittent. connection was reading good but speed was varying from 1 - 11 mb/s on a dell true mobile 1150 pc card
I immediately suspected the firmware upgrade but only when i tried to adjust
the antenna i noticed that this was effecting the connection. I squeezed the centre socket of the antennaes sma connector with a jewellers screwdriver and now the connection has been perfect since. What i really want to warn others is of a possible faulty antennae causing this type of fault and what a
coincidence with this acting up when i done an update, must have effected
it when i was removing the connections..I would also Just like to thank you for the great software..I`m a total linux novice and I`m really crawling through the tutorials. sorry for the long post but I hope that my problem may
be of help to others..? regards Jelly