Thanks for the reply! You are really quick seeing the core of the problem!
And sorry for posting too much stuff... I just don't want another broken asus router. I've already had one broken asus before and I replaced it with this one. I would probably get a heart attack if it is a hardware issue.

The situation is this:
Before installing the USB hard drive this NEVER happened. That's about two or three weeks ago, and in the first week I rebooted the router quite often. Then I had probably max 10 day uptime and then few reboots. No problems.

But when I installed the hard drive yesterday this started to happen. However it does not happen every time. Only sometimes when I reboot. I haven't figured out what causes this randomness.

Here is what my dmesg says about ethernet devices in a WORKING system (i.e. right now):
Code:
$ dmesg | grep -i eth
NET4: Ethernet Bridge 008 for NET4.0
eth0: Broadcom BCM47xx 10/100 Mbps Ethernet Controller 4.150.10.29
eth1: Broadcom BCM47xx 10/100 Mbps Ethernet Controller 4.150.10.29
eth2: Broadcom BCM4329 802.11 Wireless Controller 4.150.10.29
device eth0 entered promiscuous mode
device eth2 entered promiscuous mode
eth2: attempt to add interface with same source address.
br0: port 2(eth2) entering learning state
br0: port 1(eth0) entering learning state
br0: port 2(eth2) entering forwarding state
br0: port 1(eth0) entering forwarding state
And the same from the non-working system for comparison:
Code:
unregister_netdevice: device eth0/8107f400 never was registered
unregister_netdevice: device eth0/8107f400 never was registered
eth0: Broadcom BCM4329 802.11 Wireless Controller 4.150.10.29
device eth0 entered promiscuous mode
br0: port 1(eth0) entering learning state
br0: port 1(eth0) entering forwarding state
Pequod:~ matti$ cat jorma | grep -i eth
NET4: Ethernet Bridge 008 for NET4.0
unregister_netdevice: device eth0/8107f400 never was registered
unregister_netdevice: device eth0/8107f400 never was registered
eth0: Broadcom BCM4329 802.11 Wireless Controller 4.150.10.29
device eth0 entered promiscuous mode
br0: port 1(eth0) entering learning state
br0: port 1(eth0) entering forwarding state
What do the two lines
Code:
unregister_netdevice: device eth0/8107f400 never was registered
unregister_netdevice: device eth0/8107f400 never was registered
really mean?

That the kernel finds them but doesn't register???

If this is a hardware problem why does it still sometimes work? And when it works the connection is fine. No dropped packets and full speed.

The WL-500w has the same hardware as WL-500g Premium V1 except the wireless chip/card and the antennas.

I really appreciate your help!