If you're using hardware raid1, that golden rule is true.... However in this case, software raid1 is used.
If you create a 120 GB partition on the 1 TB disk, you can mirror the 120GB partition from disk1 onto the 120GB partition on disk2.
If both 120 GB partitions are not exactly the same size, then the golden rule kicks back in. (eg 119 mirrored to 120 results in 119)
Beware though that rebuilding a mirror can take a very long time (because limited usb-speed).
You should make sure that the mirror gets unmounted nicely in case of a reboot. You should also check different scenarios to see how the mirror holds up... e.g. a sudden lost of power, the spinning down when idle feature on some casings.





Reply With Quote
