Bekijk de volledige versie : WL-HDD lose sometimes settings and is unreachable
xlephant
11-09-2006, 20:05
Hi together,
long time since i wrote my last message here.
i have a problem if i run my wlhdd in hybrid mode (so that i able to repeat and connect to the wlhdd as a ap), sometimes after enable the power (i often disconnect it) the device not longer reachable. the wlan ssid is set to default and security is in open mode. but i'm note able to connect via wlan or lan. i have to reflash by asus tool. i run the newest from oleqs fw. does anybody have a clue how i can prohibit that?
thx a lot.
regards
Antiloop
11-09-2006, 20:26
Hi together,
long time since i wrote my last message here.
i have a problem if i run my wlhdd in hybrid mode (so that i able to repeat and connect to the wlhdd as a ap), sometimes after enable the power (i often disconnect it) the device not longer reachable. the wlan ssid is set to default and security is in open mode. but i'm note able to connect via wlan or lan. i have to reflash by asus tool. i run the newest from oleqs fw. does anybody have a clue how i can prohibit that?
thx a lot.
regards
wb xlephant ;)
perhaps you turn it almost daily off and on right?
I have seen this before, and is known to me personally
only solution I know is to NOT turn it off and on regulary
xlephant
11-09-2006, 20:40
thx antiloop.
do you know if it was also in the hybrid mode?
i ask because if i run the wlhdd in bridge only mode it is no problem to switch the wlhdd off so often you want (tested over 4-5 months). two days ago i set again to, expand my wlan area, to hybrid mode and today, after 4-6 plug offs the settings are gone. :mad:
no idea why!!
Antiloop
11-09-2006, 21:26
thx antiloop.
do you know if it was also in the hybrid mode?
i ask because if i run the wlhdd in bridge only mode it is no problem to switch the wlhdd off so often you want (tested over 4-5 months). two days ago i set again to, expand my wlan area, to hybrid mode and today, after 4-6 plug offs the settings are gone. :mad:
no idea why!!
no the thing I have seen was with 2 WL500g's (one is now my property and never had the problem when I have been using it)
and configuration was a normal one, just wep encryption no fancy stuff, I replaced it then with a new one.. (the old one is mine now) and the new one began suffering the same problem