You obvisly did something wrong with the reset procedure I described in another thread.
After giving you a static IP the powercord reset thing is a bit tricky.
Unplug it for about 10-20 seconds then press the orange button (not the reset one) as long as you put your cord in again and release it as soon as the blue ready led shines.
If you make it right you will see the orange button in front shining + some blue leds + of course the ready led. If only ready blinks you did release the ez-setup button on a wrong time.
Just try a few times...
Afterwards proceed with the firmware restore tool. That one delivered on cd.