Hi.
When I try to enable user based share access mode on my wl700 it just hangs (and the ready lamp turns off).
To get it back up running I have to press the reset button for 10 seconds and then reflash it using the firmware restoration tool.

If I uncheck the CIFS checkboxes it is possible to enable user based share access mode but then nothing happens when I try to select the Share Management -> User Management link. It's just showing a blank page.
If I tick the CIFS checkboxes when in user mode it just freezes when I press apply. I then have to reset/reflash again...

I have tried to delete all added shares (only the untouched MYSHARE1 is left), but it's no difference.

As long as I don't try to enable the user based mode I have no problem accessing the network shares, but since I can't setup any accounts I'm not able to use it as an FTP-server...

Is there any way to make a deep-deep-deep reset of this darn thing?