well, my unit worked perfectly, i wanted to setup an ddwrt in wl500g
with sp2 release

folowing instructions (first clearnvram,then restore and then ddwrt fw) i put clearnvram fw,and after that (i done it with restoration utility) unit won`t back from restoration mode.

whenever i power it, pwr light blinks (0,5 sec continously)

ofcourse immidiatly after power on, unit goes to 192.168.1.1 (pingable)

i tryed every method described on this forum or on the net (pin 10 trick),but after succesful flashing (on a restoration utility) unit won`t reboot,and when i plug it in, immidiatly goes in restoration mode

what to do?