failed setup after upgrade

[brasil41]

I just installed 1.9.2.7-7f firmware and have access to the drive via the web interface & putty.

I tried to do a new setup of the drive following the jono-wiki guide. Apparently something went wrong because this is what I see if I access the drive via putty and type df:


Filesystem 1k-blocks Used Available Use% Mounted on
/dev/root 3008 3008 0 100% /
[admin@piscina root]$

I am a bit lost. I tried to go over the jono-wiki procedure again (fdisk etc.), but it doesn't let me. This whole thing is my first linux experience and I am a lost!

What should I do?

[Fazoletti]

Can you find any errormessage if you type 'dmesg'?

The ide part should look like this:

ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
PDC20265: IDE controller on PCI bus 01 dev 08
PCI: Enabling device 01:01.0 (0004 -> 0007)
PDC20265: chipset revision 2
PDC20265: not 100% native mode: will probe irqs later
PDC20265: ROM enabled at 0x000d0000
PDC20265: (U)DMA Burst Bit DISABLED Primary PCI Mode Secondary PCI Mode.
PDC20265: FORCING BURST BIT 0x00 -> 0x01 ACTIVE
    ide0: BM-DMA at 0x0140-0x0147, BIOS settings: hda:DMA, hdb:pio
    ide1: BM-DMA at 0x0148-0x014f, BIOS settings: hdc:pio, hdd:pio
hda: SAMSUNG MP0402H, ATA DISK drive
ide2: ports already in use, skipping probe
ide3: ports already in use, skipping probe
ide4: ports already in use, skipping probe
ide5: ports already in use, skipping probe
ide0 at 0x100-0x107,0x10a on irq 6
blk: queue c00222e8, I/O limit 4095Mb (mask 0xffffffff)
hda: 78242976 sectors (40060 MB) w/8192KiB Cache, CHS=4870/255/63, UDMA(33)
Partition check:
 /dev/ide/host0/bus0/target0/lun0: p1 p2

[Ade]

I tried to go over the jono-wiki procedure again (fdisk etc.), but it doesn't let me.

What do you mean it doesn't let you? What errors do you get?

I found Jonos Wiki very useful, but you do need to make sure you type everything correctly. Often one missing character can make all the difference.

Ade