Reply With Quotewell in first place you should not have upgraded at all,
try uploading wl500g-recover.trx or something like that
it is SOMEWHERE located in a post at this forum
Registered User
After a firmware downgrade from the asus official 1.8.1.7 to 1.7.5.6, the WL500g crashed and never completed the upgrade.
Now the power light flashes and I can`t access the router.
I have tried the firmware restore software, using different versions of the firmware, but it fails to complete.
I get:
"Upload fails! please check the connection"
After that power light stop flashing.
I have tried to press the restore button in the back with and without power on the unit.
I use a Acer laptop with static IP: 192.168.1.2, Subnet 255.255.255.0 connected directely to the router.
Please help me out here, im a newbee so be gentle.
Administrator
well in first place you should not have upgraded at all,
try uploading wl500g-recover.trx or something like that
it is SOMEWHERE located in a post at this forum
My little Asus Collection: Too much to fit inhere, my 2 babies:WL500w 1.9.2.7-10(OLEG) VX2SE Yellow Lamborghini notebook
WL500g Forum Asus Files OpenDir
Asusforum.NL -- Asusforum.DE -- Asusforum.RU -- Asusforum.PL -- Asusforum.NET -- Asusforum.EU -- Asusforum.BE -- Asusforum.ES -- Asusforum.INFO
Registered User
Are you connecting wireless or wired? If you are connecting wireless, try a wired connection to one of the four ports. Make sure the ip's are in the range 192.168.1.x where x for the computer not equals 1.
Registered User
Thanks.
Took me a while to find the recovery file, but after that everything went smooth
http://wl500g.dyndns.org/wl500g-recover.trx
Registered User
hi,
i have the same problem with the wl500g
and the recover firmware not working for me
Member
I have luck because i uploaded firmware, and forgoted to turn off proxy server in my wifi network
and firmware traveled 6 times over wireles
My network gear:6 (six)ASUS WL-500G....3(three) LINKSYS WRT-54G...2 (two) LINKSYS WET-11....2 (two) PHEENET WAP011...PHEENET 108G...4(four) PCI Prism 2.5....3(three)PCI RTL8180....2(two)PCI ACX100(Ti chipset)....PCMCIA PRISM 2.5 200mW....PCMCIA PRISM 2.5 100 mW...few 8 port switches 10/100...new stuff D-Link DWL2000AP+,PHEENET WAP011RT,
Administrator
recover firmware requires establishing telnet session to the router. Use this one instead:Originally Posted by Gabriel
http://wl500g.dyndns.org/wl500g-clear-nvram.trx
it should wipe the nvram automatically.
Member
can i use this software with web interface also?
BIG Thx
PhanToMiC
Posting Permissions