Originally Posted by
Fullback
Hey, i also had installed that same image. And then reverted back to Asus firmware ( WL700gE_1.0.4.2.nas) But my hardrive was not rebuilt.
Hi Fullback, nice to see you here...
Did you read all there is to see in http://wl700g.homelinux.net/drupal/?q=node/54
especially the part about fdisk? Scroll down until you see it....
With the Asus firmware the disk has another name. Try
fdisk /dev/ide/host2/bus0/target0/lun0/disc
MY disk is in healthy conditions, and as such has an INvalid partition table:
Code:
Device contains neither a valid DOS partition table, nor Sun, SGI or OSF disklabel
Building a new DOS disklabel. Changes will remain in memory only,
until you decide to write them. After that the previous content
won't be recoverable.
The number of cylinders for this disk is set to 30401.
There is nothing wrong with that, but this is larger than 1024,
and could in certain setups cause problems with:
1) software that runs at boot time (e.g., old versions of LILO)
2) booting and partitioning software from other OSs
(e.g., DOS FDISK, OS/2 FDISK)
Warning: invalid flag 0x00,0x00 of partition table 4 will be corrected by w(rite)
Command (m for help):
YOUR disk may look quite different. You should however remove any partition.
Maybe it is even wise to install Kamikaze again, and do exactly what is said about fdisk in http://wl700g.homelinux.net/drupal/?q=node/54
And then do the Asus part all over.
Regards,
Marc