Originally Posted by
Simbol84
Кто-то уже разогнал частоту процессора с 480 MHz ... ?
Вроде писали что Олег уже разогнал процессора н16.
Да разогнать-то можно, это недолго ...
Для просмотра частоты используйте команду:
Code:
# nvram show | grep clkfreq
Показать результаты разгона:
Code:
# clkfreq=453,226,113
# clkfreq=480,240,120
# clkfreq=532,266,133
Информация о процессоре:
Code:
# cat /proc/cpuinfo
system type : Broadcom BCM4716 chip rev 1
processor : 0
cpu model : MIPS 74K V4.0
BogoMIPS : 264.19
wait instruction : no
microsecond timers : yes
tlb_entries : 64
extra interrupt vector : no
hardware watchpoint : yes
ASEs implemented : mips16 dsp
VCED exceptions : not available
VCEI exceptions : not available
unaligned_instructions : 1
System clocks
(cpu/mem/si/xtal) : 532/266/133/20 Mhz.
dcache hits : 2147483648
dcache misses : 3808163383
icache hits : 2147483648
icache misses : 1073147895
instructions : 2147483648
# dmesg
Linux version 2.6.22 (root@localhost.localdomain)
(gcc version 4.1.2) #153 Tue Jun 23 16:25:53 CST 2009
CPU revision is: 00019740
Determined physical RAM map: memory: 07fff000 @ 00000000 (usable)
On node 0 totalpages: 32767
Normal zone: 255 pages used for memmap
Normal zone: 0 pages reserved
Normal zone: 32512 pages, LIFO batch:7 Built 1 zonelists.
Total pages: 32512
Kernel command line: root=/dev/mtdblock2
console=ttyS0,115200
init=/sbin/preinit
Primary instruction cache 32kB, physically tagged, 4-way, linesize 32 bytes.
Primary data cache 32kB, 4-way, linesize 32 bytes.
Synthesized TLB refill handler (20 instructions).
Synthesized TLB load handler fastpath (32 instructions).
Synthesized TLB store handler fastpath (32 instructions).
Synthesized TLB modify handler fastpath (31 instructions).
PID hash table entries: 512 (order: 9, 2048 bytes)
CPU: BCM4716 rev 1 at 532 MHz Using 266.000 MHz high precision timer.
Dentry cache hash table entries: 16384 (order: 4, 65536 bytes)
Inode-cache hash table entries: 8192 (order: 3, 32768 bytes)
124k init available (2771k kernel code, 4856k reserved, 564k data,
Calibrating delay loop... 264.19 BogoMIPS (lpj=132096)
Mount-cache hash table entries: 512
NET: Registered protocol family 16
PCI: Using membase 8000000
PCI: Initializing host PCI: Reset RC
PCI: Fixing up bus 0
PCI: Fixing up bridge
PCI: Setting latency timer of device 0000:01:00.0 to 64
PCI: Fixing up bridge
PCI: Setting latency timer of device 0000:01:00.1 to 64
PCI: Enabling device 0000:01:00.1 (0004 -> 0006)
PCI: Fixing up bus 1
Time: MIPS clocksource has been installed.
NET: Registered protocol family 2
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
TCP established hash table entries: 4096 (order: 3, 32768 bytes)
TCP bind hash table entries: 4096 (order: 2, 16384 bytes)
TCP: Hash tables configured (established 4096 bind 4096)
TCP reno registered
VFS: Disk quotas dquot_6.5.1
Dquot-cache hash table entries: 1024 (order 0, 4096 bytes)
squashfs: version 3.4 (2008/08/26) Phillip Lougher
# wl status
SSID: "Broadcom"
Mode: Managed RSSI: 0 dBm noise: 0 dBm Channel: 11
BSSID: 00:90:4C:09:00:2D Capability: ESS ShortSlot
Supported Rates: [ 1(b) 2(b) 5.5(b) 6 9 11(b) 12 18 24 36 48 54 ]
802.11N Capable:
Chanspec: 2.4GHz channel 11 20MHz (0x2b0b)
Control channel: 11
802.11N Capabilities:
Supported MCS : [ 0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 ]
# wl cap
ap led wme pio 802.11d 802.11h rm cqa mbss16 afterburner ampdu amsdurx amsdutx
Но на всякий случай нужен консольный кабель для восстановления роутера ...
И потребуется дополнительное охлаждение для CPU ...
http://wl500g.info/showpost.php?p=172241&postcount=45
З.Ы. А можно ещё и нарастить память до 256/512 MB ...