Looks like your flash disk is formatted in the floppy style, i.e. it does not has MBR and partition table. This format is not supported.
You need to create MBR and partition and reformat your stick.
I connected my usb flash disk to ap and I can't use ftp and samba.
I have WL-500g with Oleg 1.9.2.7 CR5a firmware.
Can you help me? What I do wrong or where is the mistake?
(Tak snad mi pomuzete, moc prosim.)
May 22 21:18:00 kernel: hub.c: new USB device 00:04.0-1, assigned address 4
May 22 21:18:00 kernel: scsi0 : SCSI emulation for USB Mass Storage devices
May 22 21:18:00 kernel: Vendor: I-Stick2 Model: IntelligentStick Rev: 2.00
May 22 21:18:00 kernel: Type: Direct-Access ANSI SCSI revision: 02
May 22 21:18:00 kernel: Attached scsi removable disk sda at scsi0, channel 0, id 0, lun 0
May 22 21:18:00 kernel: SCSI device sda: 1023488 512-byte hdwr sectors (524 MB)
May 22 21:18:00 kernel: sda: Write Protect is off
May 22 21:18:00 kernel: Partition check:
May 22 21:18:00 kernel: p1 p2 p3 p4
May 22 21:18:42 kernel: usb_control/bulk_msg: timeout
May 22 21:18:57 kernel: usb_control/bulk_msg: timeout
May 22 21:19:02 kernel: usb_control/bulk_msg: timeout
May 22 21:19:07 kernel: usb_control/bulk_msg: timeout
May 22 21:19:12 kernel: usb_control/bulk_msg: timeout
May 22 21:19:17 kernel: usb_control/bulk_msg: timeout
May 22 21:19:22 kernel: usb_control/bulk_msg: timeout
May 22 21:19:27 kernel: usb_control/bulk_msg: timeout
May 22 21:19:32 kernel: usb-storage: host_reset() requested but not implemented
May 22 21:19:42 kernel: scsi: device set offline - command error recover failed: host 0 channel 0 id 0 lun 0
May 22 21:19:42 kernel: SCSI disk error : host 0 channel 0 id 0 lun 0 return code = 6050000
May 22 21:19:42 kernel: I/O error: dev 08:01, sector 2
May 22 21:19:42 kernel: EXT3-fs: unable to read superblock
Looks like your flash disk is formatted in the floppy style, i.e. it does not has MBR and partition table. This format is not supported.
You need to create MBR and partition and reformat your stick.