Does it make sense or is it possible at all to do the same with the WL-HDD?Originally Posted by Oleg
Can I use the WL500g firmware to that effect?
reason:
I suspect having some weird settings hanging around after flashing
WLHDD-1.9.2.7-4.
In particular, after the flash I could not access WL-HDD's web server.
Capturing with Ethereal showed some IPv6 packets flying around.
Err on my side or reality?
Original: fw 1.2.3.4
Used recovery too to flash 1.9.2.7-4.
Settings restored to default , but not a real confirmation
Not able to shut down pressing the front button during 5 seconds
(no access via web, but some network activity detected)
Restored fw 1.2.3.4
Settings restored to default
1.2.3.4 could be booted but behaves differently from initial situation.
Regards Frank