Samba2 webpage wont load

[kolp]

Sorry guys, transmission is working good but samba2 webpage wont load. I am not sure if what I did is right so someone else might pick it up. I changed this setting in this file: /opt/etc/xinetd.conf to adjust my ip settings so where it use to say 172.16.0.0. I changed it to mine which 192.169.0.67/73

this is this script in that file above:

only_from = localhost 10.0.0.0/8 192.169.67.73/12 192.168.0.0/16
change to your subnet accordingly and tighten security!
Successfully terminated.

Also I changed the file as per the samba config file to access the browser to 192.169.0.67/73.

Is this correct ? Is this why samba2 wont load. I looked if samba and xinetd were running and they are. So I am not sure what I am doing wrong. Also, when I am downloading and trying to shift files from the hardrive of the router to mine the computer just freezes. And then I have to restart the router again. I think the WL-500gp I has was much better than my new router WL-500W. Would anyone know why would it crash randonmly

Thank in advance.

[kolp]

I think the problem with my interface is due to the new upgrade of Samba. My previous version worked fine. Is everyone else working fine with new Samba install. Can someone please let me know if they have installed the newest samba. I have also chage the above settings to work with 192.168.x.x still no go so I am sure its not the script its the new samba install.

Thanks in advance

[ocelivise]

Solved it. Just type folowing commands:

/opt/etc/init.d/S10xinetd start
/opt/etc/init.d/S80samba start

[Serpent]

Cool! And after the first reboot?

[ocelivise]

After reboot you have to enter them again(or put them in startup scrits)