Firmware to use wl300g as client

[miraculix]

Thanx for the fast reply. I will try to flash WL300g-1.9.2.7-3c.trx can I use ASUS tools to downgrade to erlier fw ver?

[Oleg]

Sure, firmware restoration tool does not care of versions.

[miraculix]

Now I have upgraded my router using the custom fw WL300g-1.9.2.7-3c.trx. But I still have some problem getting it to work. My setup in the ASUS router is AP and bridge mode. If i run my WiFi net work as open i get a connection to the belkin router and i get a ipaddress on my ASUS router from DHCP on Belkin. But if i try to set upp security on my WiFi net it breaks down. My ASUS just keeps saying connecting.... I have tried to use WPA-PSK / TKIP and also WPA-PSK / AES but none of them works. I have surfed the forum for info on how to trubbleshoot this from linuxconsole to get more info but it didn't make me any smarter (I'm no linux guru ) I use cut and paste from USB Stick on my settings so I'm sertin that the passphrase is correct. Do you have any tips for me on how to continue?

[Oleg]

Have you tried WEP? Most likely you've some sort of incompatibility with belkin device...

[miraculix]

Currently using fw WL300g-1.9.2.7-4.trx (Saw that you released WL300g-1.9.2.7-5.trx but have not flashed it yet).

I was able to do the following:

1. Open system is working - Router joins the "MyWifiNet" automaticly on boot.
2. WEP 64bit is working - Router joins the "MyWifiNet" automaticly on boot.
3. WEP 128bit is working - Router joins the "MyWifiNet" automaticly on boot.
4. WPA-PSK partualy working - Router logg is saying connecting to MyWifiNet on boot but nerver succeds in joining after boot. If i telnet to the router an write the following command

wl join "MyWifiNet" imode bss amode wpapsk

it joins correctly and everything works fine. I can do with this but my girlfriend is not telnet friendly so I need to fix this. She keeps nagging. I never shutoff the router an it only seems to need a reboot when I'm not at home. Any suggestions?

this is my set up

[xbox] <-x-> <[ASUSWL300G]> <<<wifi>>> <[BelkinPRE-N]> <---> {internet}

[Oleg]

ok, this seems should fix WPA-PSK in the client mode. I will prepare test firmware for you.

[Oleg]

btw, could you please run

nvram get wl0_auth_mode
nvram get wl0_join

and post results? You may need to remove your PSK key.