[MOVED]Problem to enable Afterburner

[maxx]

@ Oleg:

I have some problems with a new wrt54g v 2.2.

After setting boardflags=0x0388 and reloading wl manually afterburner is enabled
but when I restart the Router it hangs and I cannot connect (no ping)

I have tried to set several values in Byte 0x39 with wlsrom but it is not writeable, the value remains still the same.

Any idea ?

If don't have a v2.2 I could donate one to you :-)


Thank you !


Here are some infos:

/tmp # wl revinfo
vendorid: 0x14e4
deviceid: 0x4320
radiorev: 0x22050000
chipnum: 0x4712
chiprev: 0x1
corerev: 0x7
boardid: 0x708
boardvendor: 0x14e4
boardrev: 0x10
driverrev: 0x33c0d00
ucoderev: 0x1180016
bus: 0x0

/tmp # nvram show |grep board
boardrev=0x10
boardtype=0x0708
boardflags2=0
boardflags=0x0118
boardnum=42


/tmp # ./wlsrom eth0
Reading srom...

0000 0008 0000 0008 0000 7db4 7fff 0000 0000
0008 0000 0000 0000 0000 0000 0000 0000 0000
0010 0000 0000 0000 00

00 0000 0000 0000 0000
0018 0000 0000 0000 0000 0000 0000 0000 0000
0020 0000 0000 0000 0000 0000 0000 0000 0000
0028 0000 0000 0000 0000 0000 0000 0000 0000
0030 0010 0000 00f0 0000 7ab0 0040 00ac 0040
0038 7ec0 7fff 0002 0000 8200 1000 12c0 0040

[Oleg]

Set your boardflags to 0x318, this will do the trick.

As for donation - hw donations are welcome, but shipping to Russia could cost you to much.

[maxx]

thank you !
check your pm