Features or stability???

[tomilius]

Congratulations! Good work, Oleg! Nice job, int.

[int]

int, thank you very much for performing number of annoying tests and figuring out which firmwares works and which does not.

Not necessary to be thankful, it is a pleasure to work with you

[auduny]

Finally, I think that this thread should be closed. New 1.9.2.7-5 firmware should fix this issue forever.

Oleg.

I know this thread is old, but it's the closest related to what i experience.

I still have reset-problems with firmware 1.9.2.7-6b. Especially after turning on wshaper. But I can't really say what is happening. Earlier today it was quite stable, but the last 4-5 hours it has rebooted randomly maybe once every 5 minuttes. I am running with raw printing and a 250 GB disk partitioned into a 50 GB fat32 and a 200GB ext3 part and running samba...

Now it seems rather stable again. But It's really anoying. My guesses are:
1. temperature of CPU
2. RAM ( I do not use swap)
3. Hardware/Driver-bug caused by other networks.
4. Something very different..

Any ideas?