Usb interfaces problems WL-500GP v2! firmware 10 fault?

[againmoon]

Usb interfaces problems WL-500GP v2
When I connect usb modems to my router, it does not recognize nothing, no vendor id , product id.
I tried with modem onda HS600, nothing,
SAMSUNG U700(HSDPA) , nothing
Siemens P990 (UMTS), nothing

WHen I connect hard disc no problem. I connected HDD IOMEGA 120 Giga no powered, ok.
I connected 500 G LANCE HDD, external supply, ok
I also connected an Iphone (it is not a modem) and it was recognized, even without external supply.
I tried with powered usb hub, but nothing changed.

Initially I tested with Koppel wl500GP v2 software (see http://koppel.cz/conferences/viewtop...r=asc&start=30). Afterwards I upgraded directly to oleg firmware 10 for WL500GPv2 and I have the same problem.
Did you ever tested file log with an usb modem in v2?
Is it a problem of firmware 10?

thanks

[wpte]

Usb interfaces problems WL-500GP v2
When I connect usb modems to my router, it does not recognize nothing, no vendor id , product id.
I tried with modem onda HS600, nothing,
SAMSUNG U700(HSDPA) , nothing
Siemens P990 (UMTS), nothing

WHen I connect hard disc no problem. I connected HDD IOMEGA 120 Giga no powered, ok.
I connected 500 G LANCE HDD, external supply, ok
I also connected an Iphone (it is not a modem) and it was recognized, even without external supply.
I tried with powered usb hub, but nothing changed.

Initially I tested with Koppel wl500GP v2 software (see http://koppel.cz/conferences/viewtop...r=asc&start=30). Afterwards I upgraded directly to oleg firmware 10 for WL500GPv2 and I have the same problem.
Did you ever tested file log with an usb modem in v2?
Is it a problem of firmware 10?

thanks

I tought you needed aditional software for this, or a custom build firmware. I'm not quite sure, because I still trust on the UTP cables.

try this topic, it might help you further:
http://wl500g.info/showthread.php?t=13480

[againmoon]

I thank you I will use it...

[againmoon]

UPDATE there is a problem in usb stack: http://koppel.cz/conferences/viewtopic.php?p=9908#9908. In openwrt there it should not be this bug. Koppel firmware is based on oleg. I repeat my question:
Do you have any experience problem in usb detection V2, expecially with usb modems?