Hello
I now that this is a silly question, but I've just updated from ASUS 1.9.2.7 to
Firmware v.1.9.2.7 CR1 [Oleg]
and which username and password should I use to telnet the router ?
thanx
Registered User
Hello
I now that this is a silly question, but I've just updated from ASUS 1.9.2.7 to
Firmware v.1.9.2.7 CR1 [Oleg]
and which username and password should I use to telnet the router ?
thanx
Administrator
same as used by webinterface.
Registered User
the webinterface as no user... only password
Moderator & Financial forum supporter :)
That means that you didn't upgrade to 1.9.2.7 properly.Originally Posted by cardoso
Push the reset button on the back of the router for at least 10 seconds while power is applied. That resets your router to its default factory settings. After that you'll have logon with default username/password and reconfigure your router. Then your router is correctly upgraded.
You can login to telnet with the same username/password as the webinterface.
Administrator
I'm also suggesting to reset to defaults. Empty user name indicates, that you've upgraded from older (pre 1.8.x.x firmware) and has not reseted to defaults. This could cause problems, due to the fact, that firmware is seriously changed and some of the options supported earlier could cause problems with new firmware. BTW, it's still possible to telnet to your router - firmware defaults to root if username is empty.
Firmware Test Member
Hello people!!
Add Portugal to the Time Zone!
Portugal are like (GMT) England !
thks for this forum
Merry Christmas and good programing!
Last edited by int; 24-12-2004 at 15:00. Reason: Optimize
Home Page
Marco Sousa from PORTUGAL
[ WL-500g - fw: 1.9.2.7-7e [Oleg] | WL-500gP - fw: 1.9.2.7-7f-USB-1.63 [Oleg&koppel.cz]]
Senior Member
on 1.9.2.7-1 (2004-12-17) not work WPA in WDS
on 1.8.1.7-3 (2004-11-15) work fine
Last edited by Oleg; 26-12-2004 at 09:48.
Posting Permissions
