Reply With QuoteThe settings should stick since they're stored on the HDD. Honestly, though, I'm not much of a BT user, so I didn't test MLDonkey very much.
Hmmm.... I tested and it seems to be saving things OK on my router.
- K.C.
Registered User
Hi all
I recently bought a WL700gE and I've just installed the newest kfurge firmware (many thanks!). I can reach mldonkey at port 4080 but if I change and save any settings (e.g., password for admin) and I power off the router and turn it on again, these settings are gone. Also downloads which were in progress are now removed. Is this normal behavior, or am I doing something wrong (I only installed the 1.0.7.8 kfurge firmware and enabled the MLDonkey in nvram)? Is it possible to store the MLDonkey settings and resume downloads after rebooting (power off - power on)?
Any help would be greatly appreciated...
Regards,
csg0078
Forum Guru
The settings should stick since they're stored on the HDD. Honestly, though, I'm not much of a BT user, so I didn't test MLDonkey very much.
Hmmm.... I tested and it seems to be saving things OK on my router.
- K.C.
Last edited by kfurge; 13-02-2008 at 01:35. Reason: Update after testing
Posting Permissions