Additional USB ports and Internal HD!

[jayajag]

@parper

nice work.

can you make some pictures for me where i can see of you fixed the hdd?
and can you say soemthing about the temps?.

best regards

[parper]

Hi,
I made my own pillars(had a couple of rubber cones of about 1cm) of some sort that is glued to the hd and the board with a glue gun.
You can put them anywhere as long as you see that the hd is supported.

You can start by glueing the stuff to the hd and then try to test fit it on to the board.
I can't take a photo of this because I don't have access to the device right now.

The heat is not a problem at all. I though it was going to be but as you notice the case has holes in it and the hd has about on 1cm of space between the board and it.

Cheers

/P