это зря вы bin файл вшили. bin файл только для upgrade уже стоящей прошивки.
а шить надо так и ТОЛЬКО trx файл:
http://www.dd-wrt.com/wiki/index.php...WL500G_Premium
Requirements:
TFTP If you are on a Debian box, simply typing apt-get install tftp will do the trick.
wl500g-clear-nvram.trx
wl500g-recover.trx
The most recent stable release of DD-WRT from the downloads page. Make sure you use the firmware specifically compiled for the Asus router. Check the readme included with the files, but it should be called something like dd-wrt.v**_asus.trx
Step 1: Connect your computer via Ethernet cable to a LAN port on the router (I used LAN port 1)
Step 2: Unplug the power cord from the router
Step 3: Wait 20 seconds
Step 4: Press and hold the reset button on the back of the router. Note that the reset button is recessed and you need a pen or paper clip to press it in. The button protruding from the back is the EZ Setup, which is not what you want to press.
Step 5: While holding the reset button, plug the power cord into the router. Continue to hold the reset button until the power light starts flashing. Let go of the reset button
Step 6: Use tftp to transfer wl500g-clear-nvram.trx to the router. The commands are as follows:
user@box:$ tftp 192.168.1.1
> mode binary
> put wl500g-clear-nvram.trx
Step 7: Tftp should report a successful file transfer in 7-15 seconds. Wait 2-3 minutes after that before unplugging the router
Step 8: Unplug the router, wait 20 seconds. Hold the reset button and plug the power cord into the router, continuing to hold the reset button until the power light flashes. Release the reset button.
Step 9: Use tftp to transfer wl500g-recover.trx to the router. Same method as above, just change the file name. Wait 2-3 minutes after tftp reports a successful file transfer before unplugging the router.
Step 10: Unplug the router, wait 20 seconds. Hold the reset button and plug the power cord into the router, continuing to hold the reset button until the power light flashes. Release the reset button.
Step 11: Use tftp to transfer the DD-WRT firmware to the router. MAKE SURE YOU USE THE CORRECT FILE. It should be be called something like dd-wrt.v**_asus.trx Do not upload a .bin file.
Step 12: Wait 2-3 minutes after tftp reports a successful file transfer before unplugging the router. Unplug the power cord from the router, wait 20 seconds, and plug the power cord back into the router.
по русски это выглядит так:
http://wl500g.info/showpost.php?p=33445
т.е. вам надо ТРИ раза шить!
когда вы прошьете trx файл, только лишь тогда на закладке Administaration/Firmware Upgrade можно будет указывать bin файл (если к примеру от прошивки micro вы хотите перейти к mini, standart или тем более vpn)