history in the busybox shell seems fixed at around the last 10 commands
Type: Posts; User: WVR
history in the busybox shell seems fixed at around the last 10 commands
Configure your main broadband router so that incoming on port 80 is sent to the Asus
Do a ps and if dropbear is running then thats it.
Then use e.g. putty from a PC to ssh into it.
The first time you connect putty should ask you if you want to save the key from the ssh server...
from the posted pics of Premium innards I can't spot the equivalent pcb connector to this:
http://www.rtg-party.dk/~eonix/P1010043.jpg
of the deluxe, so you're probably out of luck.
perhaps
rcamdmain&
I've got a 160Gb ide disk in usb enclosure attached to 500gx.
Works fine. ext3 filesystem
Well on my web gui, On lefthand menu:
IP Config -> LAN
Then get box "Host Name:"
When you hover over it says
"This field allows you to provide a
LAN hostname for
WL500g.deluxe"
Or you could...
Isn't the correct way to set the hostname via the web interface?
This sets an nvram variable, which works for me
#nvram show | grep lan_hostname
..
lan_hostname=MyAsus
#hostname
MyAsus
NB...
Maybe someone has attached to your wifi and is grabbing your stuff :o
Sure, If you are using Oleg's firmware, from PC command prompt type
telnet <ip-address-of-your-Asus>
You should know first your admin password (default is admin)
Don't forget to commit any...
Or use OpenWRT, as that seems to be more stable
http://forum.openwrt.org/viewtopic.php?id=5688&p=1
That url doesn't show anything for me.
This is what I have at the end of my post-boot:
##start samba
/usr/sbin/smbd -D -l /tmp/smbd.log -s /opt/etc/samba/smb.conf
/usr/sbin/nmbd -D -n myasus...
When that happend on mine it was normally stupid-ftpd causing it.
You have to kill it and mount the partition where you want.
It might have been been better if you had made 1st partition /opt and...
# /usr/sbin/wl -i eth1 txpwr1 -m 85
to check..
# wl txpwrlimit
Current TX Power Limit: 89 mW ( 19.50 dBm)
(it seems to go to nearest 0.25 dbm)
Depends on your connection to outside your lan.
e.g. Firewall settings , NAT etc
Your best bet would be to dump the USB modem and get one with an ethernet port. You could setup Windoze sharing of your broadband connection on your main PC ,but in my experience thats rubbish and...
Which is just as well because your email address won't accept a file >2Mbyte
If practical, your best bet would be to fit an external directional antenna that are sold for this
Thats the same as was in the GPL release on September 2nd.
CDMA build no good for UK anyway.
The posted file WAS in PC format. converted version attached
Me too. It works, but I don't know why I should use it. :confused:
The linux kernel still seems to be 2.4.20
Edit: Is it the case that this is just the final release candidate after several 1.9...
I've seen something similar when there was mismatch between the 2 ends regarding port setting of full/half duplex
All of us over at toppy.org.uk seem to be buying them from
http://www.techfever.co.uk/products.asp?recnumber=1845
but they are currently out of stock..
Edit: see...
screwing also has another meaning (something crude) in English! :rolleyes:
As for opening up the box, its easy just take off the 4 rubber feet and undo the screws underneath. NB one screw is under...
Thats exactly how I felt after I stuffed mine. I put it away for a week, then had another go after carefully re-reading wtzm's info. I'm sure you know that the chip is the other way round on the gx...