Is there any way to check the 10/100 half/full duplex modus of eth1 from the commandline?
like ethtool on linux.
ay@ray:~$ sudo ethtool eth0
Password:
Settings for eth0:
Supported...
Type: Posts; User: auduny
Is there any way to check the 10/100 half/full duplex modus of eth1 from the commandline?
like ethtool on linux.
ay@ray:~$ sudo ethtool eth0
Password:
Settings for eth0:
Supported...
Unfortunatly. The adsl-modem isn't configurable to go into any other modus than this strange switch-modus and the dhcp-server is either non configurable, or a passthorugh from my isp. Could the...
I still have problems with random resets of my wl500g, I've redirected the syslog to a nearby linuxbox without me getting any closer to the problem
Firmware: 1.9.2.7-6b
I've turned off most of...
I know this thread is old, but it's the closest related to what i experience.
I still have reset-problems with firmware 1.9.2.7-6b. Especially after turning on wshaper. But I can't really say what...
This is pictures of my wl-500g r2.40 Has ha broadcom5325
391
Hm pin10-trick refers to AMD-chip. I have such chip (I think) The revision on the board is R2.40
UPDATE: I have no AMD CHIP, but a ST-chip m29w320dt, 0on1, 8b004 vs, sgp 8b 425
Does the same...
It's not totaly dead. My guess is that it's running just fine, but none of the interfaces are up, since it's lacking MAC-addressess. I'm not sure if boot_wait=off made the device not enter recovery...
Try it? Is it a jumper (havn't opened the box yet (since I am thinking of RMA'ing it)
What is it supposed to do?
I ran Olegs firmware on my asus wl500g for a while, then I tough running openwrt would be fun. Worked nicly, but I keep having random resets. I started to looking around the nvram-variables and (for...