Thanks for your helpful instruction barsju. It almost worked in my case.
The for-loop didn't work properly. This worked well:
#!/bin/sh
for ip in $(cat /usr/local/etc/block.ip)
do
iptables...
Type: Posts; User: lukie
Thanks for your helpful instruction barsju. It almost worked in my case.
The for-loop didn't work properly. This worked well:
#!/bin/sh
for ip in $(cat /usr/local/etc/block.ip)
do
iptables...
Hi there!
Is it possible, to show which ports are being used by PCs connected to the router? Something like a local 'neststat' output. Should display wired and wlan PCs.
Can i use the netstat...
Very strange. I still can't upgrade to 1.9.2.7 official, but i could upgrade to OLEGs 1.9.2.7-7b. Hooray! And my printer HP LJ 1100 still works.
Respect! Did you change something special, Oleg? Or...
I have exectued the command, then plugged off power, hold restore and flashed the firmware: Problem still exists.
I also exectued the command, exit telnet and ipgraded with web-interface. :(
I...
I have to say that i know almost nothing about linux and the internals of the router. :(
I used your 1.6.5.3 custom Firmware to be able to get a telnet connection. After searching this forum I...
@Antiloop
This is what i called upgrade in 'manual recovery mode' with the utility. Does not work too.
@all
There is one thing i didnt notice yet: After successful upload and "preparation" of...
Perhaps these two folders have to be created manually on the USB drive:
ftp_pub
ftp_pvt
@wiz
Yes, unusual. After hitting F5 for 9minutes, waiting for the web-page to appear, i gave up.
Here are the results:
usual status with 1.7.5.6
total: used: free: shared:...
Thank you all for your help. :)
But it still doesn't want to upgrade.
The flasher says the upgrade was successful. But after doing a reset via the 'restore' button, the Powerled flashes slowly...
After the upgade i pushed the the restore button on the back as it was said.
After this the PowerLED started blinking, i had still no web access and the router was instantly in 'restore mode'.
...
Hi There!
I want to upgrade to FW 1.9.2.7 because of its 'bandwidth management' capabilities i need. I can't upgrade. After uploading of the firmware i waited 5min. Tranfer successful, PLED was...
Tested: WORKING!
Model: WL-500g
Firmware: 1.7.5.6
Device
Brandname: HP (Hewlett Packard)
Brandtype: LaserJet 1100
URL To manufacturer: http://www.hp.com
URL To product: HP Laserjet 1100
This helped my with my HP Laserjet 1100 which is connected by the LPT Port.
Follow the instructions given in the Manual.
Open the properities of your connection: 'Standard TCP/IP Port'
Select the...