2nd WL-500G as client does not work
Status showed connected to xxx but ping to routing host (1st WL-500G, with 1.9.2.7 firmware) gets no reply and no internet functions what-so-ever. Flash the client (the 2nd WL-500G) back to 1.8.2.4 everything works again. Tried a couple of times for both WDS and non-WDS modes, 1.9.2.7 never works but 1.8.2.4 always works (without even changing the settings).
Also Bandwidth Management still does not work. Has anybody managed to get it working?
ADSL XS4ALL Connection problem with firmware 1.9.2.7
After flashing my WL-500G with the latest firmware (1.9.2.7) I was unable to connect to my ISP XS4ALL.
The error I recieved is Connect script Failed.
I've tried resetting the router to the factory defaults, loading the original settings, configuring the settings by hand, etc.
XS4ALL uses a PPTP connection. The Wireless router (client) must be configured with a 10.0.0.x address and must have the default gateway set to 10.0.0.138. With the new firmware, I'm unable to configure these IP settings.
To solve te problem, I flashed the router with the previous firmware. After loading the original firmware (1.8.3) everything worked fine.
See previous post for TCP/IP Settings
See previous post for TCP/IP Settings of the Asus WL500G. If other info is needed, please let me know.
The ADSL modem is configured with the default settings, supplied by KPN. These settings should be correct, because I've never had trouble before and nothing is changed lately.
Wireless DHCP don't work with netgear MP101
I'm trying to connect a netgear MP101 to my router. If I connect it wired, it works fine. If I try to connect it wireless, it connects with the router quite easily and then it can't get an IP-address (it gets ip 169.254.103.23 with subnet 255.255.0.0), even if dhcp is working (it worked wired) :confused: . I tried several things, like manually asign it on the netgear, which gave the netgear an IP, but it wasn't connected to the network. I entered on the router an ip to the mac address. This also didn't resolved the problem. Are their more people facing this problem or heared of it? The stranged thing is that on the log page of wireless you can see that the netgear is connected, but on the dhcp release page you can't see it. But if I use a wire you can see it on the dhcp release page. I hope people can understand the problem and I hope someone can help me. BTW: I had the same problem with 1.8.2.4, that's why I upgraded to the latest version.
a small latest question: what does WMM mean on the advanced wireless page?
1 Attachment(s)
Slow internet download rate, use FW 1.9.5.0
After measuring the internet download rate (limited to 150kbits/s) I found out with firmware 1.9.2.7 I got sometimes only 20, 30 or 35 kbits/s. There is no problem with upload (my 70 kbits/s)! With firmware 1.9.5.0 I got 140-150kbits/s. Also the connection at startup is much faster.
The distance between WL-500g and WL-100g is in my case 2 floors. The signal quality in this case is on my notebook fair (35-38% in the Asus tool).
So if you have simular problems please upgrade to 1.9.5.0 and enjoy...
swiss007