Activating Afterburner (125Mbps) on the recent wl-500g units

It works on a very old Belkin F5D7230-4 (hw 1222df) ! (with Oleg's 1.9.2.7-6c-pre5 firmware)

wl revinfo:

Code:

vendorid: 0x14e4 deviceid: 0x4320 radiorev: 0x22050000 chipnum: 0x4306 chiprev: 0x3 corerev: 0x5 boardid: 0x7000 boardvendor: 0x1799 boardrev: 0x45 driverrev: 0x35a1700 ucoderev: 0x1220098 bus: 0x1

wl cap:

Code:

ap sta wet led wme pio 802.11d 802.11h rm cqa afterburner

b43_srom 14e44320:

Code:

Found pci device 14e44320 at /proc/bus/pci/01/01.0@0x40002000 Enabling device... Device memory mapped ok SROM CRC ok 0000 4001 0000 7000 1799 4320 8000 0002 0002 0008 17f0 1800 0000 0000 ffff ffff ffff ffff 0010 ffff ffff ffff ffff ffff ffff ffff ffff 0018 ffff ffff ffff ffff ffff ffff ffff ffff 0020 ffff ffff ffff ffff 0030 bdf6 6cec ffff 0028 ffff ffff ffff ffff ffff ffff 3045 11b0 0030 fb98 fe4f ffff ffff 004c ffff ffff ffff 0038 003e 0249 ffff 0000 0000 0000 0000 0701

wl gmode:

Code:

gmode Set the 54g Mode (LegacyB|Auto||GOnly|BDeferred|Performance|LRS)

nvram show | grep afterburner:

Code:

wl0_afterburner=auto wl_afterburner=auto

I left gmode in 54g Auto (1) and voila, when i connect with my Belkin F5D7011 High Speed Mode pcmcia adapter, linkspeed is @ 125 mbps ! Effective throughput at short distance is 25 mbps, with peaks above 30 mbps, quite a bit better than 54g performance (which maxed out at 20 mbps)

Anyone got any ideas why i can't see the Afterburner option when i execute "wl gmode help" ? (i've tried the srom register at 39 with value 0x020f but that didn't make any difference)

Greetz