AP scan utility

Well, one thing: when scanning the AIR LED is blinking. When I click on "Disconnect", the LED stays unlit (!). After restart of the whole router the AIR lights up again.

I cannot confirm if this is a problem (if that means the radio is switched off) as I don't have any wi-fi client device to try at the time.

Please check again the log file, whether 'wl ap 1' command is sent before disconnecting. It should if the router had been in AP mode before the scanning started (indicated as the result of 'wl ap' in the beginning of the log).

Yes, the last command issued is "wl ap 1". Anyway, AIR always turns off.

Hi all,
It work fine now for the newest firmware.

Hi All!

Unfortunately, I couldn't connect to my router with WL SCAN utility. The error message is: "Could not connect to the specified host", but I write valid data to host/user/pass-fields. How can I solve the problem?
Config: Asus WL-500G/Oleg-1.9.2.7-9

Thanks for help..

zitev

I have the same problem in version WLScan 1.1 (2008) - "ERROR: Could not connect to the specified host". No log was created after exiting application :(

Try enable telnet access on router system setup/services menu.
(ohh i don't know where can you find that option on tomato firmware...)

hi i have some problem, everything looks good but nothing happened. no results.

i have oleg WL500gpv2-1.9.2.7-10

log.txt

Router login:
admin
Password:

[admin@Router root]$
wl ap
0
[admin@Router root]$
wl scan -t passive
[admin@Router root]$
wl scanresults
wl: Not Ready
[admin@Router root]$