Printable View
I just installed my brand new WL-HDD. MY setup is a router (with DHCP server and DSL modem inside, 2 copmputers connected to the router). I want to use the WL-HDD via WLAN connection to the router with the 2 other computers.
The WL-HDD is set up so far, when i connect it to the router by LAN everything works fine. With WLAN I can't get any connection. Key, mode and the rest is set up, but I cant get it to work. Firmware is 1.1.2.8.
Any ideas ????
turn wds off.. or explain better what you want to do
and set 54mbit to auto
That didn't help.
Setup:
- WLAN/DSL-Router connected to internet
- 2 computers connected to this router via LAN
WL-HDD:
- should be connected to router via WLAN
- should be accessible by both computers
What's wrong ??
http://wl500g.info/showthread.php?t=10
follow that..
the images are not correct for 1.8.x.x or wl-hdd firmwares
but should guide you enough..
also didn't help...
restore stuff to default
can you connect to SSID WL-HDD then? (meaning without any encryption set at your client)
if yes then there is a problem in your configuration somewhere
change stuff step by step then you will find the error
I dont want to connect to SSID WL-HDD - the WL-HDD must connect to my router (SSID Polizei).......
i see.. didn't read your post too carefullyQuote:
Originally Posted by greenland
i have no idea if that client mode is working, I don't run wl-hdd firmware anymore so i can't test it
please note your brand of your router etc..
firmware
encryption bla bla bla bla
Router: T-Sinus 154 DSL
Firmware of router: 0.81
Tried it with & without encryption with no luck...
wpa or wep encryption ?Quote:
Originally Posted by greenland
with or without wds ?
in firmware 1.1.2.5 only WDS with WEP worked
I tried with & without WEP.......no WPA........
I also tried WDS & Hybrid.........to no avail.....
WL-HDD firmware is 1.1.2.8.......
So why then list two MAC adresses in your remote bridge list? (And at the same time allow anonymous)Quote:
Originally Posted by greenland
Sure your router setup is correct (AP/Gateway/Router?)
Any firewalls active on your router?
Read the manual carefully, you may have missed an obvious setting
> So why then list two MAC adresses in your remote bridge list? (And at the same time allow anonymous)
I removed the macs and just left anonymous. Still doesn't work....
> Sure your router setup is correct (AP/Gateway/Router?)
Yes, i works fine with anything else, I also can connect with a laptop via WLAN and use LAN & internet........
> Any firewalls active on your router?
no
> Read the manual carefully, you may have missed an obvious setting
I did that. You have all the settings below, so what would that be....
he means the settings of your other router not the wl-hddQuote:
Originally Posted by greenland
the WL-HDD works when using WDS with WEP encryption (firmware 1.1.2.5), thus it is either incompatible with your router or your router does not meet 802.11g specs
also possible is that the wl-hdd does not meet 802.11g specs
by now I think I tried every possible combination.....I will return the wl-hdd........