csiga
25-04-2007, 19:17
Hello,
First of all I not too familiar with Linux.
I did the custom firmware upgrade according the instruction and it worked well. My goal was the HDD spin down and it worked.
A week later the main power went out for while. I had to reconfigure the router completly because it forget all the settings. I guess it reloaded the factory default firmware.
When I reset everything it seems work fine except the HDD spin down.
I started to flash the custom SW again. When I try to telnet to move the rc.local etc. I refsused by the system. I get a fault message telling me I can't connect on port 23 (this was a free translation from my local language).
I could not solve this. I did everithing until this step several time in different way. The result is the same.
Please help.
Best regards, Csiga
First of all I not too familiar with Linux.
I did the custom firmware upgrade according the instruction and it worked well. My goal was the HDD spin down and it worked.
A week later the main power went out for while. I had to reconfigure the router completly because it forget all the settings. I guess it reloaded the factory default firmware.
When I reset everything it seems work fine except the HDD spin down.
I started to flash the custom SW again. When I try to telnet to move the rc.local etc. I refsused by the system. I get a fault message telling me I can't connect on port 23 (this was a free translation from my local language).
I could not solve this. I did everithing until this step several time in different way. The result is the same.
Please help.
Best regards, Csiga