Control
29-04-2006, 08:44
I installed nload with ipkg on my wl500-gx. ifconfig shows me the following network interfaces:
br0
eth0
eth1
lo
vlan0
vlan1
if I monitor them with nload, it shows them all to be fairly quiet (~0.7 KBit/s) except for eth0 and vlan1, which constantly show traffic between 20 and 75 kBit/s. In both cases, this traffic is incoming, with a far smaller amount outgoing. If I understand this correctly, vlan1 is the NIC which is connected to my cable modem, but I'm not sure what eth0 is. I have three computers connected to the wl500-gx, plus a USB printer and a USB HDD. Wireless is turned off and the web interface shows no dhcp leases (the three computers have manually assigned IPs). If I didn't know better, I'd say someone was downloading pr0n or something over my line, but that really can't be.
Any ideas?
br0
eth0
eth1
lo
vlan0
vlan1
if I monitor them with nload, it shows them all to be fairly quiet (~0.7 KBit/s) except for eth0 and vlan1, which constantly show traffic between 20 and 75 kBit/s. In both cases, this traffic is incoming, with a far smaller amount outgoing. If I understand this correctly, vlan1 is the NIC which is connected to my cable modem, but I'm not sure what eth0 is. I have three computers connected to the wl500-gx, plus a USB printer and a USB HDD. Wireless is turned off and the web interface shows no dhcp leases (the three computers have manually assigned IPs). If I didn't know better, I'd say someone was downloading pr0n or something over my line, but that really can't be.
Any ideas?