WDS with wl500g and MAXg router

[ACluk90]

Hello there

Because the range of my wl500g is too small my mother bought me a MAXg router for Christmas. The MAXg router has just very few functions.
I've got the following situation:
WL500g connected to internet, ...
I want to expand the wl500g's range with the MAXg router.
The MAXg and WL500g can just connect through WirelessLAN

I have tried it for hours now, what have I set up wrong??

MAXg Router
SSID: hNeth2
Broadcast SSID: enabled
Access point isolation: disabled
Bridge mode disabled (because if I enable it, I can’t connect to the router any more)
Enable WDS restrictions enabled (the correct MAC-Adresses are listed)
Channel: 11
54g mode: Automatic 54g protection
Beacon interval: 100
RTS threshold: 2347
Fragmentation threshold 2346
DTIM interval: 3
Preamble: long
IP-Address: 192.168.1.2
Subnet mask: 255.255.255.0
Mode: Accesspoint
Security: none
UpnP: off

WL500g
SSID: hNeth
Broadcast SSID: enabled
Access point isolation: disabled
Bridge mode hybrid
Connect to Aps in Bridge List enabled
Channel: 11
54g mode: Automatic 54g protection
IP-Address: 192.168.1.2
Subnet mask: 255.255.255.0
Mode: Accesspoint
Security: none
UpnP: on
System Setup: Home Gateway
Firmware: 1.9.2.7-6c-pre5 by Oleg

ACluk90

[Oleg]

SSIDs should be the same, IP addresses different, WDS should be enabled on both routers and their addresses should filled to the WDS MAC lists.

[ACluk90]

Thank you very much for your very fast answer, Oleg.

It still works just half:
when I connect to the wl-500g I can open the config-site of the MAXg router and the config site of the wl500g. very good:)
but I can't connect to MAXg router any more. :confused: :mad:

I've set it up 3 times to check what I've spelled the MAC-Addresse correct, but it never worked. I've no idea why....:confused:

ACluk90

PS: The MAXg router seems also to run Linux, even with the same bootloader, but I don't know how to communicate with it (telnet, ssh, ... doesn't work)