kamilek
28-12-2005, 09:14
I tried to connect to ISP which is using WPA EAP-PEAP/MSCHAPv2. I installed wpa_supplicant from http://ipkg.nslu2-linux.org/feeds/unslung/wl500g/ and I am using this config:
# EAP-PEAP/MSCHAPv2 configuration for RADIUS servers that use old peaplabel
# (e.g., Funk Odyssey and SBR, Meetinghouse Aegis, Interlink RAD-Series)
network={
ssid="www802cz_7391500104WPA"
proto=WPA
pairwise=TKIP CCMP
group=TKIP CCMP WEP104 WEP40
# eapol_flags=???
key_mgmt=WPA-EAP
eap=PEAP
identity="username"
password="password"
# ca_cert="/etc/cert/ca.pem"
# phase1="peapver=0 peaplabel=1"
phase2="auth=MSCHAPV2"
# priority=1
}
But when I run wpa_supplicant with command wpa_supplicant -t -w -i eth2 -c /opt/etc/wpa_supplicant.conf -D broadcom it always shut down radio part. I have to start it manually. But it is the same on next try with wpa_supplicant.
What can I do with it?
# EAP-PEAP/MSCHAPv2 configuration for RADIUS servers that use old peaplabel
# (e.g., Funk Odyssey and SBR, Meetinghouse Aegis, Interlink RAD-Series)
network={
ssid="www802cz_7391500104WPA"
proto=WPA
pairwise=TKIP CCMP
group=TKIP CCMP WEP104 WEP40
# eapol_flags=???
key_mgmt=WPA-EAP
eap=PEAP
identity="username"
password="password"
# ca_cert="/etc/cert/ca.pem"
# phase1="peapver=0 peaplabel=1"
phase2="auth=MSCHAPV2"
# priority=1
}
But when I run wpa_supplicant with command wpa_supplicant -t -w -i eth2 -c /opt/etc/wpa_supplicant.conf -D broadcom it always shut down radio part. I have to start it manually. But it is the same on next try with wpa_supplicant.
What can I do with it?