Bekijk de volledige versie : Routing in CF

10-04-2004, 14:21
Hi all, I sucessfully make my firmware, which is based on Oleg 1.7.6-2 (good work Oleg :) ).
But i have strange problem vith settings the IP for eth2 (wireless) directly. I type
ifconfig eth2 inet netmask up
but the ping from my AP isn't working. Whwn i set IP to br0 iface, all work as i expect. Why i need this? For use in our community network, the wireless clents would like to connect their networks to FreeNet, so they need the NAT.
I think the setings eth2 to client mode, association to the AP and set the NAT will be enough.

10-04-2004, 16:04
If you need to manipulate your WLAN interface separately from LAN then just enable wireless firewall.