kolaf
25-05-2005, 13:04
As I now understand it there are three separate interfaces on the wl-500gx,WAN,WLAN, and LAN. to exploit the available interfaces fully it should be possible to assign an IP address to each of them. However, using the Web interface I am only able to set the IP address on the WAN and LAN interfaces, not the WLAN interface. How do I achieve this?
Running firmware 1.9.2.7-5a
I will be using three such units to extend an ADSL connection, each of them will be connected to a separate LAN, as well as wirelessly bridging the ADSL connection further. I need to be able to route between the different interfaces so that I may filter out traffic between the different "LANs".
Running firmware 1.9.2.7-5a
I will be using three such units to extend an ADSL connection, each of them will be connected to a separate LAN, as well as wirelessly bridging the ADSL connection further. I need to be able to route between the different interfaces so that I may filter out traffic between the different "LANs".