Bekijk de volledige versie : Minolta PagePro 1200W
Hi,
there is some driver at
http://download.opendrivers.com/drv/printers/minolta/pg_scplinux.tar.gz
Is somebody here, than can compile into the wl-500g?
Thanks,
Peter
llagendiijk
07-05-2005, 18:30
Hi,
there is some driver at
http://download.opendrivers.com/drv/printers/minolta/pg_scplinux.tar.gz
Is somebody here, than can compile into the wl-500g?
Thanks,
Peter
I had a quick look, but it looks as if this thing is coded in java. As long as we don't have a java run time environment it is probably impossible to run this on the wl-500. Even with a jre it is most likely impossible due to the limited amount of memory.
But, do you really need it? I am not sure how your printer connects to the wl-500, but if it is through USB or parallel port, you can use the wl-500 as a jetdirect server... If it is through ethernet or wlan, connect to it as you would normally....
/Louis
I have connected printer to wl-500g. I checked USB and parallel port. Printer is detected good by wl-500g. But when start printing from my PC it send about 64kB and then stops. The printer prints notthing.
Peter
Antiloop
08-05-2005, 19:01
you are not telling your firmware version
I have connected printer to wl-500g. I checked USB and parallel port. Printer is detected good by wl-500g. But when start printing from my PC it send about 64kB and then stops. The printer prints notthing.
Peter
I have the 1300W and it works perfectly on the USB port. But you have to disable the "bidirectional support". I'm using Oleg's "1.9.2.7-3b".