PDA

Bekijk de volledige versie : Problem with USB key on WL-500gx



Gigen
21-04-2005, 13:07
Hi everyone!
I have a WL-500gx router with Oleng latest firmware. But when I try to connect my USB 2.0 key, the router do not recognize it. In the System log is this message:

Apr 21 13:54:00 USB storage: removed
Apr 21 13:54:05 kernel: usb.c: USB disconnect on device 01:02.2-2 address 7
Apr 21 13:56:06 kernel: hub.c: new USB device 01:02.2-2, assigned address 8
Apr 21 13:56:15 kernel: /dev/scsi/host0/bus0/target0/lun0: I/O error: dev 08:00, sector 0
Apr 21 13:56:15 kernel: I/O error: dev 08:00, sector 0

I try to format the USB key to FAT16 and FAT32, upload the firmware of router and restart to factory settings, but allways the same problem. The strange thing is because it works normaly on my notebook and on the router too.
Thank you in advance.
lp
Gigen

Antiloop
21-04-2005, 14:37
I try to format the USB key to FAT16 and FAT32, upload the firmware of router and restart to factory settings, but allways the same problem. The strange thing is because it works normaly on my notebook and on the router too.
Thank you in advance.

thus in fact you do not have a problem? here you are saying it works perfectly at your router

please explain better

Gigen
21-04-2005, 16:11
Sorry, my mistake. My english is not so good. It works on notebook. And it was working on router too, before I was playing with it.
This is the full report from system log:

Initializing USB Mass Storage driver...
Jan 1 01:00:09 kernel: usb.c: registered new driver usb-storage
Jan 1 01:00:09 kernel: scsi0 : SCSI emulation for USB Mass Storage devices
Jan 1 01:00:09 kernel: Vendor: Hotline Model: Solid Gear Rev: 2.00
Jan 1 01:00:09 kernel: Type: Direct-Access ANSI SCSI revision: 02
Jan 1 01:00:09 kernel: Attached scsi removable disk sda at scsi0, channel 0, id 0, lun 0
Jan 1 01:00:10 kernel: sda : READ CAPACITY failed.
Jan 1 01:00:10 kernel: sda : status = 1, message = 00, host = 0, driver = 08
Jan 1 01:00:10 kernel: Current sd00:00: sns = 70 6
Jan 1 01:00:10 kernel: ASC=28 ASCQ= 0
Jan 1 01:00:10 kernel: Raw sense data:0x70 0x00 0x06 0x00 0x00 0x00 0x00 0x0a 0x00 0x00 0x00 0x00 0x28 0x00 0x00 0x00 0x00 0x00
Jan 1 01:00:10 kernel: sda : block size assumed to be 512 bytes, disk size 1GB.
Jan 1 01:00:10 kernel: Partition check:
Jan 1 01:00:10 kernel: I/O error: dev 08:00, sector 0
Jan 1 01:00:10 kernel: I/O error: dev 08:00, sector 0
Jan 1 01:00:10 kernel: unable to read partition table
Jan 1 01:00:10 kernel: USB Mass Storage support registered.
Jan 1 01:00:21 kernel: SCSI device sda: 256000 512-byte hdwr sectors (131 MB)
Jan 1 01:00:21 kernel: sda: Write Protect is off
Jan 1 01:00:21 kernel: p1 p2 p3 p4
Apr 21 14:11:24 kernel: usb_control/bulk_msg: timeout
Apr 21 14:11:39 kernel: usb_control/bulk_msg: timeout
Apr 21 14:11:44 kernel: usb_control/bulk_msg: timeout
Apr 21 14:11:49 kernel: usb_control/bulk_msg: timeout
Apr 21 14:11:54 kernel: usb_control/bulk_msg: timeout
Apr 21 14:11:59 kernel: usb_control/bulk_msg: timeout
Apr 21 14:12:04 kernel: usb_control/bulk_msg: timeout
Apr 21 14:12:09 kernel: usb_control/bulk_msg: timeout
Apr 21 14:12:14 kernel: usb-storage: host_reset() requested but not implemented
Apr 21 14:12:24 kernel: scsi: device set offline - command error recover failed: host 0 channel 0 id 0 lun 0
Apr 21 14:12:24 kernel: SCSI disk error : host 0 channel 0 id 0 lun 0 return code = 6050000
Apr 21 14:12:24 kernel: I/O error: dev 08:01, sector 2
Apr 21 14:12:24 kernel: EXT3-fs: unable to read superblock