PDA

Bekijk de volledige versie : Problem with wireless



carvalho
30-03-2005, 02:03
Hi all.
This will be my first post. Congrats for the forum. Fabulous.

My problem is:
I have WL-HDD with firmware 1.2.3.0. and an AP DLink AP2000+.
The WL-HDD is connect to AP2000+ via wireless as WDS to extend my wireless network.
WEP 128, etc... everything works fine during 10 seconds!!! After that, the wlan led stars blinking and never stops. I have to unplug the AC cable to fix this.
During the "blinking state" I can't ping the WL-HDD and it dissapears from my system.

What is this?

Thanks in advance.
JosÚ

Antiloop
31-03-2005, 14:00
Hi all.
This will be my first post. Congrats for the forum. Fabulous.

My problem is:
I have WL-HDD with firmware 1.2.3.0. and an AP DLink AP2000+.
The WL-HDD is connect to AP2000+ via wireless as WDS to extend my wireless network.
WEP 128, etc... everything works fine during 10 seconds!!! After that, the wlan led stars blinking and never stops. I have to unplug the AC cable to fix this.
During the "blinking state" I can't ping the WL-HDD and it dissapears from my system.

What is this?

Thanks in advance.
JosÚ
═'ve no idea what it is,
have you tried using WDS with no encryption
also does the other side (the DLINK) support WDS ? and is it configured as WDS?

carvalho
31-03-2005, 15:11
I haven't tried without WEP.

The dlink supports WDS but if I set this mode (and WDS on WL-HDD) they don't associated.

But this behavior only happens when I switch on my laptop (IBM T40). When it's switch off, the wlan led on WL-HDD is normal, but I can't suppose what's happening...

Should I try Dlink as WDS and WL-HDD as AP?