rip13
06-05-2009, 07:33
Hello all. There is a a router wl-500g Premium. It worked with old FW and oleg`s FW 1.9.2.7-10. A few days ago I decided to try a newest official 3.0.3.6. After that problems start).
Now it says:
"
The cable for Ethernet is not pluged in. Please check ethernet cable is connected properly to the WAN port.
"
But it is. It's pluged in already. I cannot open any page from internet. But skype's slowly working and mtorrent too. I can ping any ip in lan or internet.
If i turn in this cable dirrectly to PC i have all internet.
Second, I can't do Hard Reset. That buttom doesn't work. I pushit for 5 seconds without result.
And what i hate more i can't install my old oleg`s FW 1.9.2.7-10.
This is my routing table:
Destination Gateway Genmask Flags Metric Ref Use Iface
172.17.168.255 * 255.255.255.255 UH 0 0 0 WAN
192.168.1.0 * 255.255.255.0 U 0 0 0 LAN
172.17.168.0 * 255.255.252.0 U 0 0 0 WAN
default 172.17.168.255 0.0.0.0 UG 0 0 0 WAN
I don't have 192.168.1.0 and 172.17.168.0 in my net.
Help me. What could i do?
PS: What difference between WL-500gP and WL-500gP V2? Which one do i have?
Now it says:
"
The cable for Ethernet is not pluged in. Please check ethernet cable is connected properly to the WAN port.
"
But it is. It's pluged in already. I cannot open any page from internet. But skype's slowly working and mtorrent too. I can ping any ip in lan or internet.
If i turn in this cable dirrectly to PC i have all internet.
Second, I can't do Hard Reset. That buttom doesn't work. I pushit for 5 seconds without result.
And what i hate more i can't install my old oleg`s FW 1.9.2.7-10.
This is my routing table:
Destination Gateway Genmask Flags Metric Ref Use Iface
172.17.168.255 * 255.255.255.255 UH 0 0 0 WAN
192.168.1.0 * 255.255.255.0 U 0 0 0 LAN
172.17.168.0 * 255.255.252.0 U 0 0 0 WAN
default 172.17.168.255 0.0.0.0 UG 0 0 0 WAN
I don't have 192.168.1.0 and 172.17.168.0 in my net.
Help me. What could i do?
PS: What difference between WL-500gP and WL-500gP V2? Which one do i have?