lifeisfun
02-01-2009, 14:27
I recently found this post on how to install Twonky on wl500w using factory FW:
http://www.twonkyforum.com/viewtopic.php?f=8&t=4094
Ok As I have found a solution. I will post here for other.
In fact it was quite easy. WL-ASUS 500W needs a different build. You should take MIPS little endian glibc 2.2.3. Extract it to you your attached drive. Correct all paths in the ini files. Then make a startup script, for example init.sh, which contains
#!/bin/sh
route add -net 224.0.0.0 netmask 240.0.0.0 dev br0
cd /tmp/harddisk/part0/twonkyvision
/tmp/harddisk/part0/twonkyvision/twonkymedia &
This part I can't figure out :confused:
and then put this init.sh in the USB Section /Initial script. Reboot and that should work fine.
Disable the built-in Media server before. tested with firmware 1.9.8.2 and twonky 4.4.2.
Unfortunatelly I'm having hard time to do so since I'm not Linux GURU like most of you here. Can you guys give me some advice ?
I tried to contact the original poster but I doubt that I'll get any response
Thanks
http://www.twonkyforum.com/viewtopic.php?f=8&t=4094
Ok As I have found a solution. I will post here for other.
In fact it was quite easy. WL-ASUS 500W needs a different build. You should take MIPS little endian glibc 2.2.3. Extract it to you your attached drive. Correct all paths in the ini files. Then make a startup script, for example init.sh, which contains
#!/bin/sh
route add -net 224.0.0.0 netmask 240.0.0.0 dev br0
cd /tmp/harddisk/part0/twonkyvision
/tmp/harddisk/part0/twonkyvision/twonkymedia &
This part I can't figure out :confused:
and then put this init.sh in the USB Section /Initial script. Reboot and that should work fine.
Disable the built-in Media server before. tested with firmware 1.9.8.2 and twonky 4.4.2.
Unfortunatelly I'm having hard time to do so since I'm not Linux GURU like most of you here. Can you guys give me some advice ?
I tried to contact the original poster but I doubt that I'll get any response
Thanks