How to get a HP3150 to work with the WL-500g

[pkrabbendam]

Hi,

I've successfully installed my WL-500g as an Access Point only - after the first WL-500g turned out to be not working properly, wireless signal was extremly low - but now I have problems getting my HP3150 (all-in-one, fax, scanner etc.) to work. Apparently the WL-500g does recognize that the 3150 is there, since it is being displayed when I run the 'Device Discovery'. But when I print, nothing comes out although IP-address setting etc. are correct.

I'm running firmware version 1.6.5.3 out of the box.

Any help would be greatly appreciated!!!

[brubber]

If you're running WXP:

1: Read the manual that came with the router (pdf on installation cd) and look for LPR server.

2: Check out the FAQ section of this forum and again look for LPR server.

If your not running WXP please provide more details about your workstation(s) OS