configure the wan to lan filter [Archive]

forum-smart81

29-12-2004, 11:06

hi all,
my problem is that i need a transmission from ex 2 intern. for port 80. I tryed to configure the wan to lan filter. i dont know the source ip so i dont write anything!?? or are there any wildcarts * dosnot work!!

i use version 1.6.4.8. before i must update i hope you can help me

wiz

29-12-2004, 13:59

hi all,
my problem is that i need a transmission from ex 2 intern. for port 80. I tryed to configure the wan to lan filter. i dont know the source ip so i dont write anything!?? or are there any wildcarts * dosnot work!!

i use version 1.6.4.8. before i must update i hope you can help me

wan 2 lan:

Source IP Port Range Destination IP Port Range Protocol
blank 80 blank blank TCP

this should do it.

forum-smart81

29-12-2004, 14:58

no chance it dosn´t work

Oleg

29-12-2004, 18:53

Upgrade to latest firmware first.

Styno

30-12-2004, 08:52

You also might try 1.7.5.9 CR5 which, to me, is the most stable firmware I've seen till now.

forum-smart81

04-01-2005, 13:20

hi all. now i have the newest firmware. and i need a transmission from extern to intern on port 80 for a special application. but the application dosn´t work. how can i test if the port is ok??
and what are the correct cessations??
big thanks for helping me