tiagoaleks
12-09-2007, 11:52
Hello.
I know that this question is already old, but I got a WL-500gP after seeing that we could connect two USB printers at the same time after OLEG's wonderfull firmware.
I flashed with the latest version (1.9.2.7-7g) and started to do the steps I found in this forum:
- nvram set bootCmdX="/usr/sbin/p910nd -f /dev/usb/lp1 1"
- flashfs enable, commit, save, the works.
Problem is that the command stays stored at boot (i can see it if I show nvram), but the second printer is not assigned the port 9001. If I run the command "/usr/sbin/p910nd -f /dev/usb/lp1 1" manually after switching off and on the printer it works. And I also tried sequences. Turning the router on with the printers already on, turning the printers on after the router, etc.
I suppose there is not more information for this case, is there?
I thought about running a cron job with the command "/usr/sbin/p910nd -f /dev/usb/lp1 1" every 5 minuts, but could't get cron to activate at boot. I didn't install the package because cron is already installed, and when i tried to run ipkg, the router said that the command was not found.
Another problem is that we would like to enable and disable the internet connection trough windows. The icon of the Internet Gateway that appears on the Network settings. The problem is that we can disable the connection when we want, but when we enable the connection, nothing happens. We have to restart the computers and enable the connection. Has anybody had the same experience?
Thank you for any help.
I know that this question is already old, but I got a WL-500gP after seeing that we could connect two USB printers at the same time after OLEG's wonderfull firmware.
I flashed with the latest version (1.9.2.7-7g) and started to do the steps I found in this forum:
- nvram set bootCmdX="/usr/sbin/p910nd -f /dev/usb/lp1 1"
- flashfs enable, commit, save, the works.
Problem is that the command stays stored at boot (i can see it if I show nvram), but the second printer is not assigned the port 9001. If I run the command "/usr/sbin/p910nd -f /dev/usb/lp1 1" manually after switching off and on the printer it works. And I also tried sequences. Turning the router on with the printers already on, turning the printers on after the router, etc.
I suppose there is not more information for this case, is there?
I thought about running a cron job with the command "/usr/sbin/p910nd -f /dev/usb/lp1 1" every 5 minuts, but could't get cron to activate at boot. I didn't install the package because cron is already installed, and when i tried to run ipkg, the router said that the command was not found.
Another problem is that we would like to enable and disable the internet connection trough windows. The icon of the Internet Gateway that appears on the Network settings. The problem is that we can disable the connection when we want, but when we enable the connection, nothing happens. We have to restart the computers and enable the connection. Has anybody had the same experience?
Thank you for any help.