WL500g with 2 usb ports

[Technik]

nice post Technik!

I've been so busy that I haven't has the time to check this out...
I remembered to check the forum today, and was glad to find that someone has a solution.

[Technik], please confirm that this is the correct shematic:

                ___    ____
             o-|N1 |--|GND \_
USB2      R1 o-|P1 |--|    __
pin3  --/\/\/--|P2 |--|   /
pin2  --/\/\/--|N2 |--|__/
          R2    ---
               RN28
pin 1 -- +5v
pin 4 -- gnd)


(R1=R2=15ohm)

(usb pinout: http://www.interfacebus.com/Design_Connector_USB.html#b )

Also, did you use external 15ohm resistors, or did you "reuse" the free RN2 15 Ohm resistances on the board?
where did you get the +5v from? (which part of the pcb?)
I guess a capacitor next to the +5v input of pin1 would be a nice addon, don't you think?

regards,

Thanks!
I can confirm that your schematic diagram is OK.
As soldering on small onboard SMD parts is a bit difficult, I prefer using external resistors.
I am getting 5V from the input connector as marked, not directly but through additional reversible 0.7A fuse (PolySwitch).
In case you need a high power for external HDD, I would use some additional serial coils on both 5V and GND (taken from the power input connector) and ~1.2A fuse.