Technik, I finally decide not to include cleint mode stuff like this. We need to make right firmware with no glitches. So, I've checked the init scripts in figure out how we could "natively" support client mode. So, can you please perform the following test: we need to figure out how to initialize STA mode (bss/ibss) using the "right" commands. So, in order to do this specify all wireless settings you need via the web interface, then reboot the router. In the shell prompt please enter the following commands:
Code:
wlcfg eth2 down
nvram set wl0_mode=sta
wlcfg eth2 up
and then check if wireless network functional (i.e. have associated). Also, if you need IBSS mode instead of BSS try
adding
Code:
nvram set wl0_infra=1
before eth2 up. Also you could switch it to WET (client mode bridge???) mode by specifying "wet" instead of "sta".
Also, you could probably need to set wl0_channel to 0.
Please let me know if it works for you.