вывод dmesg
Code:
usbcore: registered new interface driver usb-storage
USB Mass Storage support registered.
NTFS driver 2.1.30 [Flags: R/O MODULE].
drivers/usb/serial/usb-serial.c: USB Serial support registered for GSM modem (1-port)
option 1-1:1.0: GSM modem (1-port) converter detected
usb 1-1: GSM modem (1-port) converter now attached to ttyUSB0
option 1-1:1.2: GSM modem (1-port) converter detected
usb 1-1: GSM modem (1-port) converter now attached to ttyUSB1
option 1-1:1.3: GSM modem (1-port) converter detected
usb 1-1: GSM modem (1-port) converter now attached to ttyUSB2
usbcore: registered new interface driver option
drivers/usb/serial/option.c: USB Driver for GSM modems: v0.7.2
usbcore: registered new interface driver cdc_ether
usbcore: registered new interface driver rndis_host
usbcore: registered new interface driver cdc_wdm
usbcore: registered new interface driver qmi_wwan
cdc_ncm: 14-Mar-2012
usb 1-1: MAC-Address: 58:2c:80:13:92:63
usb0: register 'cdc_ncm' at usb-0000:00:04.1-1, Mobile Broadband Network Device, 58:2c:80:13:92:63
usbcore: registered new interface driver cdc_ncm
ADDRCONF(NETDEV_UP): usb0: link is not ready
device usb0 entered promiscuous mode
scsi 0:0:0:0: CD-ROM HUAWEI Mass Storage 2.31 PQ: 0 ANSI: 2
scsi 1:0:0:0: Direct-Access HUAWEI SD Storage 2.31 PQ: 0 ANSI: 2
sd 1:0:0:0: [sda] Attached SCSI removable disk
eth1: received packet with own address as source address
подключил как модем, а не по хайлинку.
получаю такой PPP log:
Code:
Calling GPRS/UMTS/LTE
ATZ
OK
AT+CGDCONT=1,"IP","internet.beeline.ru"
OK
ATD*99#
CONNECTchat: Jan 01 04:00:11 CONNECT
Script /tmp/ppp/peers/wan0_chat.sh finished (pid 435), status = 0x0
Serial connection established.
using channel 1
Using interface ppp0
Connect: ppp0 <--> /dev/ttyUSB0
sent [LCP ConfReq id=0x1 <mru 1492> <asyncmap 0x0> <magic 0xadf6cd01> <pcomp> <accomp>]
rcvd [LCP ConfReq id=0x1 <accomp> <pcomp> <asyncmap 0x0> <mru 1500> <magic 0x553> <auth chap MD5>]
sent [LCP ConfAck id=0x1 <accomp> <pcomp> <asyncmap 0x0> <mru 1500> <magic 0x553> <auth chap MD5>]
rcvd [LCP ConfAck id=0x1 <mru 1492> <asyncmap 0x0> <magic 0xadf6cd01> <pcomp> <accomp>]
sent [LCP EchoReq id=0x0 magic=0xadf6cd01]
rcvd [CHAP Challenge id=0x1 <f5d4a361d123f41a607cc08c5ff6ce33>, name = "HUAWEI_CHAP_SRVR"]
sent [CHAP Response id=0x1 <66c98b3be9e89a831a50bae0c44a64f5>, name = "beeline"]
rcvd [LCP EchoRep id=0x0 magic=0x553]
rcvd [CHAP Success id=0x1 "Welcome!!"]
CHAP authentication succeeded: Welcome!!
CHAP authentication succeeded
sent [CCP ConfReq id=0x1 <mppe -H -M -S -L -D +C> <deflate 15> <deflate(old#) 15>]
sent [IPCP ConfReq id=0x1 <addr 0.0.0.0> <ms-dns1 0.0.0.0> <ms-dns2 0.0.0.0>]
rcvd [IPCP ConfReq id=0x1]
sent [IPCP ConfNak id=0x1 <addr 0.0.0.0>]
rcvd [LCP ProtRej id=0x2 80 fd 01 01 00 12 12 06 00 00 00 01 1a 04 78 00 18 04 78 00]
Protocol-Reject for 'Compression Control Protocol' (0x80fd) received
rcvd [IPCP ConfNak id=0x1 <ms-dns1 0.0.0.0> <ms-dns2 0.0.0.0>]
sent [IPCP ConfReq id=0x2 <addr 0.0.0.0> <ms-dns1 0.0.0.0> <ms-dns2 0.0.0.0>]
rcvd [IPCP ConfReq id=0x2]
sent [IPCP ConfAck id=0x2]
sent [IPCP ConfReq id=0x2 <addr 0.0.0.0> <ms-dns1 0.0.0.0> <ms-dns2 0.0.0.0>]
sent [IPCP ConfReq id=0x2 <addr 0.0.0.0> <ms-dns1 0.0.0.0> <ms-dns2 0.0.0.0>]
sent [IPCP ConfReq id=0x2 <addr 0.0.0.0> <ms-dns1 0.0.0.0> <ms-dns2 0.0.0.0>]
sent [IPCP ConfReq id=0x2 <addr 0.0.0.0> <ms-dns1 0.0.0.0> <ms-dns2 0.0.0.0>]
sent [IPCP ConfReq id=0x2 <addr 0.0.0.0> <ms-dns1 0.0.0.0> <ms-dns2 0.0.0.0>]
sent [IPCP ConfReq id=0x2 <addr 0.0.0.0> <ms-dns1 0.0.0.0> <ms-dns2 0.0.0.0>]
sent [IPCP ConfReq id=0x2 <addr 0.0.0.0> <ms-dns1 0.0.0.0> <ms-dns2 0.0.0.0>]
sent [IPCP ConfReq id=0x2 <addr 0.0.0.0> <ms-dns1 0.0.0.0> <ms-dns2 0.0.0.0>]
IPCP: timeout sending Config-Requests
sent [LCP TermReq id=0x1a "No network protocols running"]
sent [LCP TermReq id=0x1b "No network protocols running"]
Connection terminated.
Modem hangup
Это хорошо или плохо? связи всё еще нет.
UPD: Заработало.
Заменил модем beeline hawei e3131 на mts huawei 420s, который как я понимаю и есть e3131.