New Asus RT-N66U Router

[zhdan]

wpte

What switching to US? Write manual, please!

[wpte]

wpte

What switching to US? Write manual, please!

Open telnet (you can turn it on in the administration of the router)
before you do anything you might want to check this value and make note of it:

nvram get pci/1/1/ccode

To change to us:

nvram set pci/1/1/ccode=US
nvram set pci/2/1/ccode=US
nvram set wl0_country_code=US
nvram set wl1_country_code=US
nvram set regulation_domain=US
nvram set regulation_domain_5G=US
nvram commit

do a reboot and your router will allow 500mW for 2.4GHz and 250mW for 5.2GHz connections.
Please keep in mind that the US allows different network channels, especially for 5GHz: http://en.wikipedia.org/wiki/List_of...2Fh.2Fj.2Fn.29

to go back to eu mode is easy:

nvram set pci/1/1/ccode=EU
nvram set pci/2/1/ccode=EU
nvram set wl0_country_code=EU
nvram set wl1_country_code=EU
nvram set regulation_domain=EU
nvram set regulation_domain_5G=EU
nvram commit

[ArCan]

Open telnet (you can turn it on in the administration of the router
...
do a reboot and your router will allow 500mW for 2.4GHz and 250mW for 5.2GHz connections.
...

I'm using Shibby 097 right now and several others f/w for RT-N66U but never stock f/w
and never see any changes in the level of signal even do set "Transmit Power" from 0(default to hardware) to max 500/250...
:-(
The dafault settings for my router are
"pci/1/1/ccode=0
pci/2/1/ccode=0
wl0_country_code=US
wl1_country_code=US
regulation_domain=US
regulation_domain_5G=Q2"

I changed it to "US" for all without any success.

I'm using the inSSIDer for control the lever of WiFi signals and always have almost plane line for both bands.
And doesn't matter 0...500 I fill in in "Transmission Power"

Only the position of router antennas dramaticaly change the level of signals (in the reseption place) !!!

Could you explain my situation and post your results of dependence level of signal and parameter in "Transmit Power".

P.S. I never see information that somebody changed the "Transmission Power" and had higher level of signal in air...
Will appriciate for links with really convincing results.
Thank you.

P.P.S. ... may be the reason for my negative expirience the third part firmware
and with stock firmware you have positive results for changes the transmit power...
I don't know...

[wpte]

I'm using Shibby 097 right now

It's ment for stock firmware. I don't use any other firmware than oleg or stock