Прошивки для Asus RT-N16
Странно. Пропало сообщение. В общем: получил я новую прошивку для RT-N16. Ядро - 2.6.22!
Скорость ЮСБ пока не измерял.Code:CFE version 1.0.37 for BCM947XX (32bit,SP,LE) Build Date: Thu Dec 4 16:48:54 CST 2008 (root@localhost.localdomain) Copyright (C) 2000-2008 Broadcom Corporation. Init Arena Init Devs. Boot partition size = 262144(0x40000) et0: Broadcom BCM47XX 10/100/1000 Mbps Ethernet Controller 5.10.56.3 CPU type 0x19740: 532MHz Tot mem: 131072 KBytes CFE mem: 0x80700000 - 0x8079AE30 (634416) Data: 0x80731670 - 0x807343A0 (11568) BSS: 0x807343A0 - 0x80734E30 (2704) Heap: 0x80734E30 - 0x80798E30 (409600) Stack: 0x80798E30 - 0x8079AE30 (8192) Text: 0x80700000 - 0x80731670 (202352) Device eth0: hwaddr 00-90-4C-08-00-2D, ipaddr 192.168.1.1, mask 255.255.255.0 gateway not set, nameserver not set Null Rescue Flag. Loader:raw Filesys:raw Dev:flash0.os File: Options:(null) Loading: ...... 3360304 bytes read Entry at 0x80001000 Closing network. Starting program at 0x80001000 Linux version 2.6.22 (root@localhost.localdomain) (gcc version 4.1.2) #32 Fri Mar 6 21:19:31 CST 2009 CPU revision is: 00019740 Determined physical RAM map: memory: 07fff000 @ 00000000 (usable) Built 1 zonelists. Total pages: 32512 Kernel command line: root=/dev/mtdblock2 console=ttyS0,115200 init=/sbin/preinit Primary instruction cache 32kB, physically tagged, 4-way, linesize 32 bytes. Primary data cache 32kB, 4-way, linesize 32 bytes. Synthesized TLB refill handler (20 instructions). Synthesized TLB load handler fastpath (32 instructions). Synthesized TLB store handler fastpath (32 instructions). Synthesized TLB modify handler fastpath (31 instructions). PID hash table entries: 512 (order: 9, 2048 bytes) CPU: BCM4716 rev 1 at 532 MHz Using 266.000 MHz high precision timer. Dentry cache hash table entries: 16384 (order: 4, 65536 bytes) Inode-cache hash table entries: 8192 (order: 3, 32768 bytes) Memory: 126320k/131068k available (2619k kernel code, 4608k reserved, 540k data, 120k init, 0k highmem) Mount-cache hash table entries: 512 NET: Registered protocol family 16 PCI: Using membase 8000000 PCI: Initializing host PCI: Reset RC PCI: Fixing up bus 0 PCI: Fixing up bridge PCI: Fixing up bridge PCI: Enabling device 0000:01:00.1 (0004 -> 0006) PCI: Fixing up bus 1 Time: MIPS clocksource has been installed. NET: Registered protocol family 2 IP route cache hash table entries: 1024 (order: 0, 4096 bytes) TCP established hash table entries: 4096 (order: 3, 32768 bytes) TCP bind hash table entries: 4096 (order: 2, 16384 bytes) TCP: Hash tables configured (established 4096 bind 4096) TCP reno registered VFS: Disk quotas dquot_6.5.1 Dquot-cache hash table entries: 1024 (order 0, 4096 bytes) squashfs: version 3.4 (2008/08/26) Phillip Lougher NTFS driver 2.1.28 [Flags: R/O]. fuse init (API version 7.8) io scheduler noop registered (default) HDLC line discipline: version $Revision: 1.1.1.1 $, maxframe=4096 N_HDLC line discipline registered. Serial: 8250/16550 driver $Revision: 1.1.1.1 $ 4 ports, IRQ sharing disabled serial8250: ttyS0 at MMIO 0x0 (irq = 8) is a 16550A loop: module loaded PPP generic driver version 2.4.2 PPP Deflate Compression module registered PPP BSD Compression module registered PPP MPPE Compression module registered NET: Registered protocol family 24 PPPoL2TP kernel driver, V0.17 Physically mapped flash: Found 1 x16 devices at 0x0 in 8-bit bank Amd/Fujitsu Extended Query Table at 0x0040 Physically mapped flash: CFI does not contain boot bank location. Assuming top. number of CFI chips: 1 cfi_cmdset_0002: Disabling erase-suspend-program due to code brokenness. Flash device: 0x2000000 at 0x1c000000 Physically mapped flash: squashfs filesystem found at block 1734 Creating 4 MTD partitions on "Physically mapped flash": 0x00000000-0x00040000 : "boot" 0x00040000-0x01fe0000 : "linux" 0x001b1848-0x01fe0000 : "rootfs" 0x01fe0000-0x02000000 : "nvram" Found a 0MB serial flash sflash: found no supported devices Netfilter messages via NETLINK v0.30. nf_conntrack version 0.5.0 (1023 buckets, 8184 max) ctnetlink v0.93: registering with nfnetlink. IPv4 over IPv4 tunneling driver GRE over IPv4 tunneling driver ip_tables: (C) 2000-2006 Netfilter Core Team TCP cubic registered NET: Registered protocol family 1 NET: Registered protocol family 10 IPv6 over IPv4 tunneling driver NET: Registered protocol family 17 Ebtables v2.0 registered 802.1Q VLAN Support v1.8 Ben Greear <greearb@candelatech.com> All bugs added by David S. Miller <davem@redhat.com> VFS: Mounted root (squashfs filesystem) readonly. Freeing unused kernel memory: 120k freed Warning: unable to open an initial console. [sighandler]: No more events to be processed, quitting. [cleanup]: Waiting for children. [cleanup]: All children terminated. read from nvram insmod: ip_conntrack_ftp.ko: no module by that name found insmod: ip_nat_ftp.ko: no module by that name found insmod: nls_utf8.ko: no module by that name found Hit enter to continue...read from nvram waitpid: No child processes insmod: ip_nat_starcraft.ko: no module by that name found insmod: ipt_NETMAP.ko: no module by that name found insmod: ip_conntrack_ftp.ko: no module by that name found insmod: ip_nat_ftp.ko: no module by that name found waitpid: No child processes vlan1: No such device vlan1: No such device interface vlan1 does not exist! eth1: Invalid argument eth1: Invalid argument eth1: Invalid argument eth1: Operation not supported waitpid: No child processes telnetd: starting port: 23; interface: any; login program: /bin/sh waitpid: No child processes info, udhcp server (v0.9.8) started killall: upnp: no process killed UPnP::upnp_device_attach:br0: attach InternetGatewayDevice.xml U2EC start ... UPnP::upnp_init:UPnP daemon is ready to run insmod: soundcore.ko: no module by that name found waitpid: No child processes insmod: audio.ko: no module by that name found insmod: videodev.ko: no module by that name found The inherited fd(3) is closed. cannot get proto entry: No such file or directory cannot get proto entry: No such file or directory killall: wps_monitor: no process killed killall: wps_ap: no process killed killall: wps_enr: no process killed Debug::sharedkeystr=(null) time.nist.gov: Unknown host # Enable direct rule **** clean ip_conntrack 1 time. **** **** clean ip_conntrack 2 time. **** echo for PaN ::: &&&PaN Hit enter to continue...Starting full scan! **** clean ip_conntrack 3 time. **** killall: ntpclient: no process killed time.nist.gov: Unknown host killall: ntpclient: no process killed time.nist.gov: Unknown host
Reply With Quote
Originally Posted by Oleg
Впрочем есть проблемы серьёзней: сеть не работает. Не знаю, как китайцы проверяли своё детище, но факт налицо. Впрочем и ЮСБ приходится не только вручную монтировать, но и девайсы создавать. 
? Хотя, догадываюсь, какой будет ответ...
Ведь, когда 3 человека работают над общей целю гораздо лучше чем 2!!!
