На r1143 все нормально:
Code:
usbcore: registered new interface driver usbfs
usbcore: registered new interface driver hub
usbcore: registered new device driver usb
USB20H mdio control register : 0x80000018
PCI: Setting latency timer of device 0000:00:04.1 to 64
ehci_hcd 0000:00:04.1: EHCI Host Controller
ehci_hcd 0000:00:04.1: new USB bus registered, assigned bus number 1
ehci_hcd 0000:00:04.1: irq 5, io mem 0x18004000
ehci_hcd 0000:00:04.1: USB 0.0 started, EHCI 1.00, driver 10 Dec 2004
usb usb1: configuration #1 chosen from 1 choice
hub 1-0:1.0: USB hub found
hub 1-0:1.0: 2 ports detected
SCSI subsystem initialized
Initializing USB Mass Storage driver...
usbcore: registered new interface driver usb-storage
USB Mass Storage support registered.
eth0: no IPv6 routers present
br0: no IPv6 routers present
eth1: no IPv6 routers present
vlan1: no IPv6 routers present
usb 1-2: new high speed USB device using ehci_hcd and address 2
usb 1-2: configuration #1 chosen from 1 choice
scsi0 : SCSI emulation for USB Mass Storage devices
usb-storage: device found at 2
usb-storage: waiting for device to settle before scanning
scsi 0:0:0:0: Direct-Access JetFlash TS512MJF2A 1.00 PQ: 0 ANSI: 2
sd 0:0:0:0: [sda] 1023488 512-byte hardware sectors (524 MB)
sd 0:0:0:0: [sda] Write Protect is off
sd 0:0:0:0: [sda] Mode Sense: 37 00 00 08
sd 0:0:0:0: [sda] Assuming drive cache: write through
sd 0:0:0:0: [sda] 1023488 512-byte hardware sectors (524 MB)
sd 0:0:0:0: [sda] Write Protect is off
sd 0:0:0:0: [sda] Mode Sense: 37 00 00 08
sd 0:0:0:0: [sda] Assuming drive cache: write through
sda: unknown partition table
sd 0:0:0:0: [sda] Attached SCSI removable disk
usb-storage: device scan complete
FAT: utf8 is not a recommended IO charset for FAT filesystems, filesystem will !
Unable to load NLS charset cp866
FAT: codepage cp866 not found
#fdisk -l
Disk /dev/sda: 524 MB, 524025856 bytes
17 heads, 59 sectors/track, 1020 cylinders
Units = cylinders of 1003 * 512 = 513536 bytes
Device Boot Start End Blocks Id System
/dev/sda1 ? 3213726 3459668 123339962 78 Unknown
Partition 1 has different physical/logical beginnings (non-Linux?):
phys=(518, 102, 15) logical=(3213725, 10, 17)
Partition 1 has different physical/logical endings:
phys=(743, 0, 62) logical=(3459667, 11, 55)
Partition 1 does not end on cylinder boundary
/dev/sda2 ? 431577 1204941 387841909+ 10 Unknown
Partition 2 has different physical/logical beginnings (non-Linux?):
phys=(205, 7, 0) logical=(431576, 6, 36)
Partition 2 has different physical/logical endings:
phys=(920, 235, 50) logical=(1204940, 1, 57)
Partition 2 does not end on cylinder boundary
/dev/sda3 ? 1863971 3777461 959615034 8b Unknown
Partition 3 has different physical/logical beginnings (non-Linux?):
phys=(260, 125, 54) logical=(1863970, 11, 5)
Partition 3 has different physical/logical endings:
phys=(893, 46, 60) logical=(3777460, 4, 15)
Partition 3 does not end on cylinder boundary
/dev/sda4 ? 33389 41687 4161536 a OS/2 Boot Manager
Partition 4 has different physical/logical beginnings (non-Linux?):
phys=(269, 111, 50) logical=(33388, 12, 25)
Partition 4 has different physical/logical endings:
phys=(0, 0, 0) logical=(41686, 15, 25)
Partition 4 does not end on cylinder boundary
Partition table entries are not in disk order
Originally Posted by PASHKA
Есть забавная проблема в последней прошивке от Олега (которая 5).Клиенты так и не появляются. Понять последовательность почему это происходит или не происходит я пока не смог.
впрочем в 1.9.2.7-rtn она уже не воспроизводится.
