Asus WL-500gP è 3G ìîäåì ZTE MF622/MF626/MF627

[oleg71]

Dao_Dezi - ïîïðîáóþ åùå....ñìîòðåë åñòü ñêðèïò ïèíãà - è åñëè ïèíãà íåò òî äîëæåí áûë áûòü ATZ ìîäåìà è óáèéñòâî pppd è ðåêîííåêò...
íî ó ìåíÿ ýòî íå ñðàáîòàëî! Ïîêîâûðÿþ åùå... Íàäî á ðàçîáðàòüñÿ ñ ýíåðãîñáåðåãàþùèì ðåæèìîì (ïî÷èòàþ êîìàíäû ÀÒ)

À âîò êàê íà÷àëñÿ âîñêðåñíûé äåíü Ìîäåì âèñèò - ãîðèò äèîäèê... èíåòà íåò... äåëàþ ïåðåçàãðóçêó... ëîã ñðàçó ïîñëå reboot:
-----------------------

syslogd started: BusyBox v1.13.3
...
Jan  1 03:00:03 kernel: PPP generic driver version 2.4.2
Jan  1 03:00:03 kernel: PPP Deflate Compression module registered
Jan  1 03:00:03 kernel: PPP BSD Compression module registered
Jan  1 03:00:03 kernel: MPPE/MPPC encryption/compression module registered
Jan  1 03:00:03 kernel: PPPoL2TP kernel driver, V0.13 (oleg@cs.msu.su)
Jan  1 03:00:03 kernel:  Amd/Fujitsu Extended Query Table v1.1 at 0x0040
Jan  1 03:00:03 kernel:  Flash Id: Vendor: 0x00c2 Device: 0x00cb
Jan  1 03:00:03 kernel: number of CFI chips: 1
Jan  1 03:00:03 kernel: cfi_cmdset_0002: Disabling fast programming due to code brokenness.
Jan  1 03:00:03 kernel: Flash device: 0x800000 at 0x1c000000
Jan  1 03:00:03 kernel: Physically mapped flash: squashfs filesystem found at block 780
Jan  1 03:00:03 kernel: Creating 5 MTD partitions on "Physically mapped flash":
...
Jan  1 03:00:04 dnsmasq[73]: read /etc/hosts - 2 addresses
Jan  1 03:00:04 kernel: usb.c: registered new driver usbdevfs
Jan  1 03:00:04 kernel: usb.c: registered new driver hub
Jan  1 03:00:04 kernel: usb-ohci.c: USB OHCI at membase 0xb8003000, IRQ 6
Jan  1 03:00:04 kernel: usb-ohci.c: usb-00:03.0, PCI device 14e4:471a
Jan  1 03:00:04 kernel: usb.c: new USB bus registered, assigned bus number 1
Jan  1 03:00:04 kernel: hub.c: USB hub found
Jan  1 03:00:04 kernel: hub.c: 2 ports detected
Jan  1 03:00:04 kernel: ehci_hcd 00:03.1: PCI device 14e4:471a
Jan  1 03:00:04 kernel: ehci_hcd 00:03.1: irq 6, pci mem b8003800
Jan  1 03:00:04 kernel: usb.c: new USB bus registered, assigned bus number 2
Jan  1 03:00:04 kernel: ehci_hcd 00:03.1: illegal capability!
Jan  1 03:00:04 kernel: ehci_hcd 00:03.1: USB 0.0 enabled, EHCI 1.00, driver 10 Dec 2004/2.4
Jan  1 03:00:04 kernel: hub.c: USB hub found
Jan  1 03:00:04 kernel: hub.c: 2 ports detected
Jan  1 03:00:05 kernel: usb.c: registered new driver usblp
Jan  1 03:00:05 kernel: printer.c: v0.13: USB Printer Device Class driver
Jan  1 03:00:05 kernel: usb.c: registered new driver audio
Jan  1 03:00:05 kernel: audio.c: v1.0.0:USB Audio Class driver
Jan  1 03:00:05 kernel: SCSI subsystem driver Revision: 1.00
Jan  1 03:00:06 kernel: hub.c: new USB device 00:03.1-1, assigned address 2
Jan  1 03:00:06 kernel: hub.c: USB hub found
Jan  1 03:00:06 kernel: hub.c: 2 ports detected
Jan  1 03:00:06 kernel: Initializing USB Mass Storage driver...
Jan  1 03:00:06 kernel: usb.c: registered new driver usb-storage
Jan  1 03:00:06 kernel: USB Mass Storage support registered.
Jan  1 03:00:06 kernel: vlan1: Setting MAC address to  00 1f c6 d8 0e a6.
Jan  1 03:00:06 kernel: VLAN (vlan1):  Underlying device (eth0) has same MAC, not checking promiscious mode.
Jan  1 03:00:06 dnsmasq[73]: read /etc/hosts - 2 addresses
Jan  1 03:00:06 kernel: hub.c: new USB device 00:03.1-1.1, assigned address 3
Jan  1 03:00:06 dhcp client: deconfig: lease is lost
Jan  1 03:00:07 kernel: usb.c: registered new driver serial
Jan  1 03:00:07 kernel: usbserial.c: USB Serial support registered for Generic
Jan  1 03:00:07 kernel: usbserial.c: USB Serial Driver core v1.4
Jan  1 03:00:11 kernel: usb_control/bulk_msg: timeout
Jan  1 03:00:11 kernel: usb.c: USB device not accepting new address=3 (error=-145)
Jan  1 03:00:12 kernel: hub.c: new USB device 00:03.1-1.1, assigned address 4
Jan  1 03:00:12 pppd[107]: In file /tmp/ppp/peers/dialup: unrecognized option '/dev/usb/tts/2'
Jan  1 03:00:17 kernel: usb_control/bulk_msg: timeout
Jan  1 03:00:17 kernel: usb.c: USB device not accepting new address=4 (error=-145)
Jan  1 03:00:17 kernel: hub.c: new USB device 00:03.1-1.2, assigned address 5
Jan  1 03:00:17 kernel: scsi0 : SCSI emulation for USB Mass Storage devices
Jan  1 03:00:17 kernel:   Vendor: USB 2.0   Model: Storage Device    Rev: 0100
Jan  1 03:00:17 kernel:   Type:   Direct-Access                      ANSI SCSI revision: 02
Jan  1 03:00:17 kernel: Attached scsi disk sda at scsi0, channel 0, id 0, lun 0
Jan  1 03:00:17 kernel: SCSI device sda: 58605120 512-byte hdwr sectors (30006 MB)
Jan  1 03:00:17 kernel: Partition check:
Jan  1 03:00:18 kernel:  /dev/scsi/host0/bus0/target0/lun0: p1 p2 p3
Jan  1 03:00:27 kernel: Adding Swap: 528360k swap-space (priority -1)
Jan  1 03:00:27 kernel: kjournald starting.  Commit interval 5 seconds
Jan  1 03:00:27 kernel: EXT3-fs warning: maximal mount count reached, running e2fsck is recommended
Jan  1 03:00:27 kernel: EXT3 FS 2.4-0.9.19, 19 August 2002 on sd(8,2), internal journal
Jan  1 03:00:27 kernel: EXT3-fs: mounted filesystem with ordered data mode.
Jan  1 03:00:27 kernel: kjournald starting.  Commit interval 5 seconds
Jan  1 03:00:27 kernel: EXT3 FS 2.4-0.9.19, 19 August 2002 on sd(8,3), internal journal
Jan  1 03:00:27 kernel: EXT3-fs: mounted filesystem with ordered data mode.
Jan  1 03:00:27 USB storage: ext3 fs at /dev/discs/disc0/part3 mounted to /tmp/mnt/disc0_3

---------------------------------------------------------------------
â ïðîöåññàõ "ps" - pppd íåò. ïîòîì:

[admin@wl500 root]$ pppd call dialup
pppd: In file /tmp/ppp/peers/dialup: unrecognized option '/dev/usb/tts/2'

[admin@wl500 root]$ ls /dev/usb/tts
ls: /dev/usb/tts: No such file or directory